549841
11
Zoom out
Zoom in
Previous page
1/13
Next page
37
During the process of cooling some water will be extracted from the air into the unit. If the reservoir is full, both
the compressor and motor will stop and the units would buzz (you can press any button to stop the buzz), only the
fan runs to circulate the air. The W.F. indicator will flash to show you.
To make the cooling work again, please empty the water by one of the following ways:
1. Turn off the air conditioner and avoid
moving it while full.
2. Position a container (a water tray e.g.)
underneath the drain hole.
3. Remove the drain knob & rubber plug from
the drain hole and allow the water to drain
out.
4. When the container is almost full, replace
the rubber plug in the drain hole to stop the
water and empty the water tray.
5. Repeat until the unit is emptied.
6. Replace the rubber plug and tighten the
drain knob firmly.
7. Switch on the unit – the full water or
compressor indicator should not be flashing.
2
By water tube (continuous drainage)
1. Remove the drain knob and rubber plug
and retain for future use.
2. Connect the drain tube supplied to the
water outlet as shown and locate the other
end into a drain.
3. The drain tube may be extended by adding
an extension tube and using a suitable
connector.
NOTE: The drain must be at or below the outlet
level. Flashing comp/”full water” indicator will
not function in this mode of drainage. If you
want to extend the water tube connect it with
another tube (OD:18mm)
MAINTENANCE
11


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Suntec Wellness Dynamic 6.0 Plus at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Suntec Wellness Dynamic 6.0 Plus in the language / languages: English as an attachment in your email.

The manual is 0,35 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info