PART 1 • English
4
4.0 CONTROLS/FUNCTIONS
4.1 Front Panel
1. LED (4 Digit)
Displays the time in “Stand-By” mode and the channel number when the unit is operating.
2. IR Sensor
Detects the infra-red command signals generated by the remote control handset
3 & 4. Channel q & p
Move the cursor Up or Down in an application screen or change channels sequentially Up or Down in normal operation.
5. Power Button
Switches the receiver between “Stand-By” and “On” modes
6. Smart card reader
Insert your CryptoWorks smart card with golden contacts facing down.
4.2 Rear Panel
1. SAT OUT
Gives you the possibility to connect an extra receiver (analogue or digital).
2. SAT IN
Connect the cable from your LNB on the satellite dish to this connector.
3. VCR SCART
To connect your receiver to your video recorder using a scart cable. Your video
signal will now be looped through your receiver to your TV set.
4. TV SCART
To connect your receiver to your TV set using a SCART cable.
5. S/PDIF Digital audio output
Use this coaxial output to connect your receiver to the input of your digital audio amplifier
6. AUDIO-R and AUDIO-L
Audio Right (RED) and Audio Left (White) RCA connectors to connect to audio amplifier
7. Power On/Off switch
8. Power Cord
Your receiver requires a current of 90 - 250 V AC (Auto-selectable), 50/60 Hz +/-5%.
Make sure to check the power specification before connecting your receiver to the wall outlet.