Manual Stokke Xplory (page 43 of 90) (English, German, Dutch, Danish, French, Italian, Polish, Portuguese, Swedish, Turkish, Spanish, Norwegian, Finnish)

450900

Zoom out

Zoom in

1/90

36 STOKKE

XPLORY

STOKKE

XPLORY

Folding. (1-3)

STOKKE® XPLORY® back wheels:

1. All four wheels must touch the

ground. Do NOT start by lifting the

unit/back wheels to fold them in.

(See Figure 1).

2. Push bottom part (B) of the

handle on the spine UP, then – while

holding this – press the top part (A)

of handle in – and at the same time –

lift this handle UP. (See Figure 2)

3. Now, push with your foot on the

lower part of footpeddle (C) located

at top of the arch. Continue to push

with your foot, while pulling the

steering handle towards you. (See

Figure 3)

Unfolding (2)

STOKKE® XPLORY® back wheels:

Pull the bottom part (B) of the

handle on the spine UP, then – while

holding this in position – press the

top part (A) of the handle in – and at

the same time – lift the main steering

handle UP and forward. The legs will

release. (See Figure 2)

If the unit’s wheels are locked in

a folded position and difficult to

release, give the foot-peddle a slight

push – with either your hand or foot

- while you unfold the back wheels.

Adjusting the handle, height and

angle (4)

Lift the trigger (D) and hold it up

while you adjust the handle to the

desired height. The handle height can

be adjusted to any position in a range

between 67 and 116 cm/26,4 and

45,7 inch. The handle can be adjusted

to 4 different angles by pressing the

trigger (E) down and rotating the

handle.

Seat Assembly (5)

Push the seat down on the seat arm

until a click is heard on each side.

The seat may be mounted in a posi-

tion facing forwards or backwards.

Check that the seat is properly

mounted on the seat arms by

ensuring that the indicators found on

each side of the seat have changed

colour from red to green.

Adjusting the seat angle (6)

The seat angle is adjusted by means

of the handle (G) on the seat arm.

Note! Always keep your hand on the

seat when you adjust the angle. The

seat has 3 positions facing

backwards, and 2 positions facing

forward.

WARNING!

Never assemble, remove or turn the

seat while your child is in it.

SEAT Dissasembly (7)

Press the service handles in on each side

of the seat simultaneously and lift the

seat off the seat arms. The child should

not be in the seat during this procedure.

Adjusting the seat height (8)

Release the handle (F), move the seat

arm to the desired height and lock the

handle by pressing it back into place.

Please make sure that you always hold

the seat arm by the centre sleeve that

attaches it to the centre column, the seat

arm will then be easy to move. Adjustable

height is 50 to 70 cm from the bottom of

the seat.

Mounting and adjusting the foot rest

(9)

Push the footrest up the tracks. Check

to make sure that the footrest is locked

in position. Dismounting and adjusting the

footrest downwards is done by pushing

the handles (J) on both sides up and mov-

ing the footrest in the tracks. To provide

the best comfort possible, adjust the

footrest to support your child’s feet.

Seat rail (10)

Release seat rail on both sides and pull

the rail up. Insert the seat rail into place.

A click will be heard when the rail is

placed correctly.

Warning! Do not use the rail for carrying.

Brake (11)

Always remember to engage the brakes

when you park the stroller. Do this by

pressing the lower part of the brake

pedal. To release the brake, press the

upper part of the brake pedal.

Removing and attaching the back

wheels (12)

Release the locking device and pull the

wheel off the axle. To attach push the

wheel onto the axle until you hear a click.

Check to make sure that the wheel is

locked on to the axle.

Use on stairs (13)

Stokke Xplory’s unique design enables

it to negotate obstacles such as thresh-

olds and kerbs with ease. Stokke Xplory

is especially easy to transport up/down

stairs using the two-wheel

function. The child must not be sitting

in the stroller while it is going up/down

stairs because transporting a child in a

stroller on stairs is generally dangerous.

Baby insert (14)

To ensure the best possible sitting

comfort for your child make sure that

the depth of the seat corresponds to

the length of the child’s thigh. The

edge of the seat should fit to the back

of the child’s knee. The padded baby

insert is attached by putting the safety

harness through the opening that best

fits the child’s shoulder height. The

baby insert is recommended up to the

age of about 15 months.

Assemble hood on seat (15)

Position and push the hood plastic

fasteners in on each side of the seat.

Attach the hood to the seat fabric with

the zipper. Attach the push buttons on

each side.

Dismounting hood from seat (16)

Unbutton on each side of the hood.

Unzip to release the hood. Release

plastic fasteners from seat by pressing

the two taps on the inside of the seat.

Use both tombs and press.

Hood visor (17)

Attach and detach the visor from the

hood with the zip. Fold in and out.

Ventilation in hot weather (18)

Unzip the zip on the hood. Fold the

cover over the edge.

Adjusting the harness (19)

Your child should always use the

harness. Tighten the harness straps

so that the harness fits your child.

The harness is opened by pressing the

release mechanisms together. As the

child grows, adjust the harness

fasteners at the back so that they

correspond to the child’s

shoulder height, see table. Thread the

strap through the fabric parts again.

STOKKE is not responsible if you

choose to use a harness other than

the one supplied! Nonetheless there

are D-rings on the waist belt for fitting

your own harness.

WARNING

Always use the crotch strap in

combination with the waist belt.

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Stokke Xplory in the language / languages: English, German, Dutch, Danish, French, Italian, Polish, Portuguese, Swedish, Turkish, Spanish, Norwegian, Finnish as an attachment in your email.

The manual is 6,69 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Stokke Xplory Manual

Product: