Manual Stiga Dino 45 (page 5 of 9) (English)

608689

Zoom out

Zoom in

1/9

ENGLISH

Preferably use environmentally friendly petrol, i.e.

alkylate petrol. This type of petrol has a

composition that is less harmful to people and

nature. It has e.g. no lead additives, no oxygenators

(alcohols and ethers), no alkenes and no benzene.

NOTE! If you change to environmentally friendly

petrol in a motor previously run on ordinary lead-

free petrol (95), the petrol manufacturer’s

recommendations must be followed carefully.

Ordinary lead-free 95 octane petrol can also be

used. You must never use 2-stroke petrol mixed

with oil. NOTE! Bear in mind that lead-free petrol

is a perishable; do not purchase more petrol than

can be used within thirty days.

STARTING THE ENGINE

1. Place the lawn mower on flat, firm ground. Do

not start in high grass.

2. Make sure the spark plug lead is connected to

the spark plug.

3. When starting a cold engine: Press down the

primer fully 6 times (fig. 9).

When starting a warm engine the primer does

not need to be used. If the engine stops due to a

lack of petrol, refill and press down the primer

three times.

4. Press in the Start/Stop-loop G against the

steering. Note that the Start/Stop loop G must

be kept pressed-in to prevent the engine from

stopping (fig. 7,8).

5. Grasp the starter handle and start the engine by

pulling briskly on the starter handle.

Keep hands and feet well away from the

rotating blade. Never put your hand or

foot under the blade casing or in the

grass evacuation unit while the engine is

running.

STOP OF ENGINE

The engine may be very warm

immediately after it is shut off. Do not

touch the silencer, cylinder or cooling

flanges as it can cause burns and injury.

1. Release Start/Stop-loop G (fig. 7,8) to stop the

engine. This loop must not be disengaged (e.g.

through fixing it in the depressed position

against the steering), as the engine cannot be

stopped.

2. If the lawn mower is left unattended to, remove

the lead from the spark plug.

CUTTING HEIGHT

Shut off the engine before adjusting the

cutting height.

Do not set the cutting height so low that

the blade can hit uneven ground.

Avoid mowing when the grass is wet. The

grass then sticks to the underside of the casing,

giving poor mowing results.

The cutting height can be adjusted to three

positions by moving the wheel axles (fig. 10).

If the start/stop loop no longer works,

stop the engine by removing the lead

from the spark plug. Immediately take

the lawn mower to an authorised

workshop for repairs.

MAINTENANCE

No service is to be made on the engine or

lawn mower without first switching off

the engine and removing the spark plug

cable from the spark plug.

Stop the engine and remove the spark

plug cable if the mower is to be lifted, e.g.

with transportation.

If the machine is to be tilted the fuel tank

must be emptied and the sparking plug of

the engine kept upwards.

CLEANING

After each time it is used the mower should be

cleaned. This is particularly important on the

underside of the mower casing. Wash out with the

garden hose. The mower will then last longer and

function better.

High pressure washing units should not be used. If

grass has dried on to the mower casing it can be

removed by scraping. If necessary, give the

underside a touch of paint to prevent rusting.

Clean the silencer and the surrounding

area regularly to remove grass, dirt and

flammable waste products.

COOLING SYSTEM

Before use, the engine's cooling system should be

cleaned. Clean the cylinder's cooling fins and the

air intake, removing any grass cuttings, dirt and the

like.

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Stiga Dino 45 in the language / languages: English as an attachment in your email.

The manual is 0,34 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Stiga Dino 45 Manual

Product: