457706

Stiebel Eltron CON 15ZS Manual

17
Zoom out
Zoom in
Previous page
1/20
Next page
17
Français
Nederlands
Caractéristiques techniques
(voir également les tableau de page 14)
Classe de protection I
Etendue de réglage des températures env.
7 ºC à env. 30 ºC
Position hors gel approx. 7 ºC
Protection contre les projections d'eau
IP24
Label de controle: voir la plaque
signalétique.
Installation de sécurité
Les appareils CON 10 – 30 S/ZS possèdent
un limiteur de température* qui coupe le
chauffage en cas de danger de surchauffe.
Si cela se produit, il faut en supprimer la
cause (sorties d'air recouvertes par
exemple). Après un temps de refroidisse-
ment de quelques minutes, l'appareil se
remet à fonctionner. S'il se pro-duit alors
une nouvelle coupure par sur-chauffe,
c'est que l'appareil est défectueux.
* Dispositif de disjonction thermique à réenclenchement
automatique
Que faut-il faire en cas de . . .
Le remplacement du cáble d'alimentation
doit être effectué par l'installateur en
utilisant un cáble d'origin de Stiebel Eltron
(voir tab. 2).
Si le convecteur ne chauffe pas, il faut véri-
fier tout d'abord le bon état des fusibles.
Si les fusibles sont intact, contacter votre
installateur.
Remise en mains
Expliquez à l’usager le fonctionnement du
convecteur soufflant. Attirez son attention
sur le fait que les ouvertures d’entrée et
de sortie de l’air ne doivent en aucun cas
être obstruées. Remettez à l’usager ce
mode d’emploi et ces instructions de mon-
tage afin qu’il les conserve soigneusement.
Technische gegevens
(zie ook tabel aan bladzijde 14)
Beveiligingsklasse I
Temperatuur-inzetbereik ca. 7 ºC tot
ca. 30 ºC
Vorstbeveiliging ca. 7 ºC
Spuitwaterdicht IP24
Kehrmerk: zie typeplaatje.
Veiligheidsinrichting
De CON 10 – 30 S/ZS bezitten een over-
verhittingsbescherming*, die bij gevaar de
verwarming uitschakelt. Wanneer de over-
verhittingsbescherming het apparaat heeft
uitgeschakeld, kan de storing worden ver-
holpen (b. v. afgedekte luchtuitstroom-
opening). Na een afkoelingsperiode van
een paar minuten kan het apparaat weer
worden ingeschakeld. Wanneer de over-
verhittingsbescherming bij het opnieuw in
gebruik nemen weer aanslaat, is het toestel
defect.
* Automatisch terugstellende veiligheids-temperatuur-
begrenzer
Wat te doen, indien . . . ?
Bij vervanging van de aansluitleiding moet
deze van de installateur door een origineel
Stiebel Eltron onderdeel (zie tab. 2).
Verwarmt de convector niet, kontroleer
dezekeringen in de meterkast. Zijn de
zekeringen niet kapot, waarschuv dan de
installateur.
Aflevering
Verklaar de gebruiker de functie van het
apparaat. Vestig er zijn aandacht op dat de
luchtingang en luchtuitgang in geen geval
mogen afgedekt worden. Geef hem deze
gebruiks- en montageaanwijzing en vraag
hem ze zorgvuldig te bewaren.
English
Technical data
(See also table on page 12)
Protection class I
Temperature range from about 7 ºC to
about 30 ºC
Frost protection about 7 ºC
Splash protection IP 24
Approvals: see the rating label.
Safety features
CON 10 – 30 S/ZS are equipped with
over temperature protection*, which
switches off the heating element in the
event of a malfunction. If the over tempera-
ture protection operates, the cause of this
must be found out and corrected (eg
covered air-exit opening). The heater will
operate again after a cooling time of
several minutes. If the over temperature
protection repeatedly operates when the
unit is switched on further advice should
be sought from Stiebel Eltron.
* Self-setting safety thermal cut-out
What to do in case . . .
Using the original Stiebel Eltron sparepart
(see tab. 2).
When the heater does not heat up, first
check the fuse. If the fuse is in order, than
call the installer.
If the electric cable needs to changed,
than it must be done by a scilled installer.
Handing over
Explain to the new user how the appliance
operates and make him aware that the air
inlet and outlet must, under no circumstan-
ces, be blocked or covered. These instruc-
tions should also be handed over and are
to be carefully kept.
… 17 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Stiebel Eltron CON 15ZS at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Stiebel Eltron CON 15ZS in the language / languages: English, German, Dutch, French as an attachment in your email.

The manual is 0,3 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info