619142
5
Zoom out
Zoom in
Previous page
1/8
Next page
2. Slide the guide rods down into the DAP tower
frame then tilt the guide gods towards the inside
of the DAP as shown.
3. Slide the rubber bumpers up and off of the guide
rods and set aside for re installation later.
4. With the top plate still attached to the DAP via
the cable, slide top plate up and off of the guide
rods. Set the top plate behind the DAP with the
cable still attached.
Note: the guide rods and collars will remain
in the DAP tower, tilted as shown.
5. One weight plate at a time slide 18 weight plates
onto the guide rods.
Note: the weight plates must be loaded with
the Lock N Load switches closest to the rear
of the DAP. The plates in the right tower will
mirror those in the left tower.
Page 5
6. After all the weight plates have been installed
slide the top plate back onto the guide rods.
7. Slide the rubber stops back onto the guide rods
as shown.
8. Set the black plastic centering caps on top of
each guide rod then tilt the guide rods back into
the DAP tower. Holding the guide rods push
them upward until the black plastic centering
caps push into the DAP tower frame.
9. While holding the guide rods in place have
another person tighten the four set screws
located in the shaft collars, that were loosened in
step one.
Black cap fully
inserted
Black cap fully
inserted
Black cap fully
inserted
Black cap fully
inserted
5


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for StarTrac IP-D9302 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of StarTrac IP-D9302 in the language / languages: English as an attachment in your email.

The manual is 1,72 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info