720574

Stanley SLM-196-510-SP Manual

11
Zoom out
Zoom in
Previous page
1/93
Next page
11
release lever(21) towards the upper bar.
3. Fix the Bowden cables to the bar using the two cable
clamps(6).
4. Slowly pull the starter cord (23) on the starter handle
towards the bar and hook the starter cord into the starter
cord guide (22/Fig.6).
5. Lift the rear impact protection(7). Hook the grass
collection box (20) into the mounting provided for this on
the rear of the equipment. Release the impact protection
(Fig.8).
Caution: The mulch kit (27) and side ejection channel(28)
must be removed before using the grass collection box.
6. Dismantling the Grass Collection
Box: Lift the impact protection and remove the grass
collection box.
7. Caution: Before using the mulch kit (27), the side
ejection channel (28) must be removed.
- Remove the grass collection box if it is installed. Lift
the impact protection. Insert the mulch kit.
- Removing the Mulch Kit: Lift the impact protection.
Remove the mulch kit .
8. Caution: Before using side grass ejection (28), the
mulch kit (27) must be installed and the grass collection
box removed.
Install the mulch kit. Lift the side impact protection (16).
Hook in the side ejection channel (28) and release the
side impact protection.
5.2 Installing the operation panel (Fig.7)
Insert the operation panel into the upper handle. You
will hear it lock in.
Then tight it with the machine using 4 screws.
5.3 Filling with Engine Oil and
Checking the Oil Level
Place the equipment on a level base.
1. Unscrew the oil filler cap and dipstick (8) and pour oil
into the tank.
2. To check the oil level, wipe the dipstick on a clean
cloth and replace it in the tank until it stops.
3. After pulling it out, read off the oil level on the
dipstick. The oil level should be in the marked area
between the minimum and maximum marks.
4. Wipe off any spilt oil and close the oil filler cap .
5.4 Filling with Petrol
Warning! Petrol is flammable and hazardous to
health:
- Keep petrol in containers intended for this purpose;
- Only refuel outdoors and never with the engine running
or when the machine is hot;
- Open the filler cap carefully to allow excess pressure to
escape;
- Do not smoke whilst refuelling;
- Avoid skin contact and inhalation of the fumes;
- Remove spilt petrol;
- Keep petrol away from sparks,open flames and other
ignition sources;
- Do not use petrol/oil mixtures;
- Use normal or super unleaded petrol;
- Only use clean, fresh petrol;
- Do not store petrol for longer than one month, as its
quality deteriorates.
1. Unscrew the filler cap (9) and pour in the petrol to the
lower edge of the filler. Do not fill the tank entirely, to
allow the petrol room to expand.
2. Wipe away petrol residues around the filler cap and
close the filler cap.
6. Operation
General Working Instructions
• As far as possible, mow the lawn when it is dry in
order to protect the turf.
• Set the cutting height such that the equipment is not
G
B
… 11 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Stanley SLM-196-510-SP at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Stanley SLM-196-510-SP in the language / languages: English, German, Danish, Italian, Portuguese, Swedish, Norwegian, Finnish as an attachment in your email.

The manual is 4,31 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info