The MEK-4 is designed to remote the front panel microphone to the rear panel of compatible
Standard Horizon Marine VHF’s. If you have any questions or comments regarding the MEK-
4, visit www.standardhorizon.com to send an E-Mail, or contact the Product Support team at
(714) 827-7600 ext 6300 or Parts at ext 6800 M-F 7:00-5:00PST.
The MEK-4 contains the following items
Quantity Description Replacement Part number
1 20FT of routing cable(with Hex nut & Gasket) T9101567
1 Stainless Steel Mounting Plate RA0946300
1 Rubber connector gasket RA0946400
3 Stainless steel screws U24312020
INSTALLATION
1. Locate and remove the rear panel gasket covering the 6-pin connector and install it on
the front panel microphone connector.
Figure 1
Figure 2
2. Use the template to mark the location, drill a 1” (24 mm) hole and three holes approx.
0.08” (2 mm) on the wall (Figure 1).
3. Install the Rubber Cap and Holder Plate to the wall using supplied three screws
(Figure 2)
4. Connect the Extension Cable to the Holder Plate using the Nut (Figure 2).
Figure 3
5. Connect the 20’ Extension Cable to
Remote Mic connector on the
transceiver’s rear panel. (Figure 3).
6. Plug in the front panel mic into the
MEK-4. The installation is now
complete.
STANDARD HORIZON, Marine Division of Vertex Standard
10900 Walker Street Cypress, CA 90630
www.standardhorizon.com
EAF71X100
φ
2
.
0
31.2 mm
1
8
m
m
9
m
m
φ
2
4
Gasket
Routing Cable
Mounting Plate
Hex Nut
Rubber Connector Gasket
Wall
Need help? Post your question in this forum.
Report abuse
Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.
Product:
Forumrules
To achieve meaningful questions, we apply the following rules:
First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.
Register
Register getting emails for Standard Horizon MEK-4 at:
new questions and answers
new manuals
You will receive an email to register for one or both of the options.
Get your user manual by e-mail
Enter your email address to receive the manual of Standard Horizon MEK-4 in the language / languages: English as an attachment in your email.
The manual is 0,19 mb in size.
You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.
The manual is sent by email. Check your email
If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.
The email address you have provided is not correct.
Please check the email address and correct it.
Your question is posted on this page
Would you like to receive an email when new answers and questions are posted? Please enter your email address.
