542726
43
Zoom out
Zoom in
Previous page
1/48
Next page
43SPEKTRUM DX9 • TRANSMITTER INSTRUCTION MANUAL
EN
Problem Possible Cause Solution
Aircraft will not Bind (during
binding) to transmitter
Transmitter too near aircraft during binding
process
Move powered transmitter a few feet from
aircraft, disconnect and reconnect flight bat-
tery to aircraft
Aircraft or transmitter is too close to large metal
object
Move the aircraft or transmitter away from the
large metal object
The bind plug is not installed correctly in the
bind port
Install bind plug in bind port and bind the air-
craft to the transmitter
Flight battery/Transmitter battery charge is too
low
Replace/recharge batteries
Aircraft will not link (after
binding) to transmitter
Transmitter too near aircraft during linking pro-
cess
Move powered transmitter a few feet from
aircraft,
disconnect and reconnect flight battery to
aircraft
Aircraft or transmitter is too close to large metal
object
Move the aircraft or transmitter away from the
large metal object
Bind plug left installed in bind port
Rebind transmitter to the aircraft and remove
the bind plug before cycling power
Aircraft bound to different model memory
(ModelMatch™ radios only)
Select correct model memory on transmitter
Flight battery/Transmitter battery charge is too
low
Replace/recharge batteries
Transmitter may have been bound using different
DSM protocol
Bind aircraft to transmitter
Damagedremotereceiverorreceiverextension. Required remote receiver is not connected.
The receiver goes into failsafe
mode a short distance away from
the transmitter
Checkthereceiverantennatobesureitisnot
cut or damaged
Replace or contact Horizon Product Support
Main and remote receivers too near each other
Install main and remote receivers at least 2
inches (51mm) apart
Receiver quits
responding during operation
Low battery voltage Completelyrechargeightbattery
Loose or damaged wires or connectors between
battery and receiver
Do a check of the wires and connection be-
tween battery and receiver. Repair or replace
wires and/or connectors
Receiver loses its bind Bind button pressed before transmitter powered on Rebind by performing binding instructions
Receiver slowly blinking at
landing(DSM2Only)
Loss of power to the receiver during flight Checkbatteryvoltage
System powered on and connected, then receiv-
er powered off without powering off transmitter
Power off transmitter when receiver is
powered off
Flight log registers undesirable
number of fades, losses or holds
or aircraft responds irregularly to
controls
Poor signal reception
Reposition remote receivers for improved RF
signal path diversity
Electronic feedback
Checkforandstopfeedbackfromservosor
motorsystemstotheESCorreceiver
Low power
Checkaircraftpowerdrawandincreasebat-
tery power or decrease power demand by
installed systems. Ensure all aircraft batteries
arefullycharged.EnsuretheinstalledBECfor
an electric aircraft is adequate for the power
demand
TROUBLESHOOTING GUIDE
43


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Spektrum DX9 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Spektrum DX9 in the language / languages: English as an attachment in your email.

The manual is 10,85 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Spektrum DX9

Spektrum DX9 User Manual - German - 47 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info