773627

Spectra S2 Plus Manual

14
Zoom out
Zoom in
Previous page
1/15
Next page
Spectra S1 Plus / S2 Plus Breast Pump Instructions for Use
{00169689 2} 14
P is the maximum output power
rating of the transmitter in watts.
d is the recommended separation
distance in meters.
Field strength from fixed RF
transmitters, as determined by an
electromagnetic site survey,a
should be less than the
compliance level in each
frequency range.b
Interference may occur in the
vicinity of equipment marked
with the following symbol.
a Field strengths from fixed transmitters, such as base stations for radio (cellular/cordless) telephones and land mobile radios,
amateur radio, AM and FM radio broadcast and TV broadcast cannot be predicted accurately. If you wish to use the equipment
in the vicinity of fixed RF transmitters and you are uncertain about the electromagnetic environment, please consider obtaining
an electromagnetic site survey. If the measured field strength in the location where the equipment is being used exceeds the
applicable RF compliance level above, it is the user’s responsibility to verify that the equipment is operating normally. If
abnormal performance is observed, additional measures, such as re-orienting or relocating the equipment, may be necessary.
b Over the frequency range 150 kHz to 80MHz, field strengths should be less than 3 V/m.
TABLE 3: Recommended Separation Distances (IEC 60601-1-2:2007)
This equipment is intended for use in an electromagnetic environment in which radiated RF disturbances are controlled.
Observing the recommended separation distances between this equipment and other portable and mobile RF
communications equipment (transmitters) can reduce the likelihood of electromagnetic interference.
Rated Maximum
Output Power of
Transmitter (W)
Separation Distance (m) Based on Frequency of Transmitter
150 kHz – 80 MHz
d = 1.2√P
80 MHz – 800 MHz
d = 1.2√P
800 MHz – 2.5GHz
d = 2.3√P
0.01
0.12
0.12
0.23
0.1
0.37
0.37
0.74
1
1.2
1.2
2.3
10
3.7
3.7
7.4
100
12
12
23
For transmitters rated at a maximum output power not listed above, the recommendation separation distance d in meters (m)
can be estimated using the equation applicable to the frequency of the transmitter, where P is the maximum output power
rating of the transmitter in watts (W) according to the transmitter manufacturer.
NOTE 1: At 80 MHz and 800 MHz, the separation distance for the higher frequency range applies.
NOTE 2: These guidelines may not apply in all situations. Electromagnetic propagation is affected by absorption and
reflection from structures, object and people.
… 14


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Spectra S2 Plus at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Spectra S2 Plus in the language / languages: English as an attachment in your email.

The manual is 4.36 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info