562247
9
Zoom out
Zoom in
Previous page
1/10
Next page
GB - 8
RADIO OPERATION
1. Press RADIO ON/BAND button once to turn on radio power, RADIO will
light up on the LCD.
2. Press RADIO ON/BAND button again to select radio band.
3. PresstheTUNE/TIMEbutton+or–momentarily(lessthan0.5sec.)tostepupordownthereceiving
frequency in order to select the desired station.
4. Forautotuning,keeppressingtheTUNE/TIMEbutton+or–(morethan0.5sec.)untilthedisplayed
frequency starts to change, then release the button. Tuning will stop automatically when a station is
received.
5. AdjustthesoundlevelbypressingVOLUME+/–buttons.
6. To turn the unit off after use, simply press STOP/OFF button once.
NOTE: After radio frequency is displayed for about 10 seconds, the LCD will show the current time.
Pressing the RADIO ON/BAND button once will show radio frequency again.
Improving the reception
Extend the FM wire antenna which is located on the back of unit, and change its position until the
best FM reception is found.
The unit has a built-in ferrite bar antenna for AM radio reception. Check the condition of AM reception
beforexingthisunitinposition.
Install the unit as far as possible from a source of noise. (for example : refrigerator, microwave oven,
uorescentlamp,etc.)
PRESET STATIONS
1. Press the RADIO ON/BAND button to the desired band.
2. When the desired station is tuned, press CD MODE / PROGRAM button
to enter saving mode.
3. ThepresetlocationwillashontheLCD,pressPRESET / button
to select preset channel.
4. Press CD MODE / PROGRAM button again to save into memory. If it has previously set, the former
station is replaced.
5. Repeat step 1 ~ 4 to store more preset stations.
NOTE: The preset memory can store a maximum of 12 stations for FM band and 12 stations for AM
band.
RECALL A PRESET STATION
To recall any preset stations within the selected band, simply press the PRESET / buttons until
the preset radio frequency appears on the display.
TIMER OPERATION (Count-down timer)
TIMER SETTING
- PressTIMERADJUST+or–todesiredcount-downtime,themaximum
count-down time is 120 minutes, with a 1 minute interval selection.
- Press the TIMER button once to start counting, the timer indicator will
light up.
- When the timer has been set and is counting, the LCD will show the count-down, however, current
time, radio frequency and CD playing track can also be displayed by pressing:
1. CLOCK button once to show current time and CD playing track when unit is in CD play mode.
2. CLOCK button once to show current time when unit is in radio on mode.
3. RADIO ON/BAND button once to show current radio frequency when unit is in radio on mode.
4. CLOCK button once to show current time when unit is in stop/off mode.
About 5 seconds later, LCD will resume to show timer count-down.
- To cancel timer operation, simply press TIMER button once, the timer indicator will turn off.
- When desired time has elasped, refer to below section for details.
CDK108 UR2080 ib 37.indd 8 2010/4/28 2:44:51 PM
9


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Soundmaster UR 2080 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Soundmaster UR 2080 in the language / languages: English as an attachment in your email.

The manual is 1,05 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Soundmaster UR 2080

Soundmaster UR 2080 User Manual - German - 7 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info