812396
15
Zoom out
Zoom in
Previous page
1/16
Next page
Malfunctions/Maintenance
Replacing the Fuse
Repairs and maintenance may only be performed by a specialist. Before working on the unit, switch off the power sup-
ply and secure it against being switched on again! Check that there is no power flowing!
Only use the supplied spare fuse or a fuse of the same design with the following specifications: 2 AT/250 VSOREL Art.
No.: 2125
If the mains voltage is switched on and the controller still
does not function or display anything, then the internal
device fuse may be defective. In that case, open the
device as described in section C, remove the old fuse
and check it.
Exchange the defective fuse for a new one, locate the
external source of the error (e.g. the pump) and
exchange it. Then first recommission the controller and
check the function of the switch outputs in manual mode
as described in Section 3.2..
Maintenance
In the course of the general annual maintenance of your heating system, the functions of the controller should also
checked by a specialist and the settings should be optimized if necessary.
Performing maintenance:
lCheck date & time ()
lAssess/check plausibility of statistics (see Section 2)see " Serve for function control and long-term monitoring of
the system. " on page 9
lCheck the error memory see " Error Messages " on page 10
lVerify/check plausibility of the current measurement values see " Measurement values " on page 9
lCheck the switch outputs/consumers in manual mode see " Manual " on page 10
lPossibly optimize the parameter settings.
Possible error messages
Possible error messages Notes for the specialist
Check time Means that the solar pump is/was in operation between 11:00 PM and 4:00 AM. Normally hap-
pens when the clock is incorrectly set, but can also suggest a malfunction while the solar cir-
culation pump was in operation outside of hours with sun.
Time & Date This display appears automatically after a longer network disruption, because the time & date
must be examined and, if applicable, adjusted.
Sensor x defective Means that either the sensor, sensor input on the controller or the connection line is / or was
defective
(see " Temperature Resistance Table for Pt1000 Sensors " on page 8)
AL failed Is displayed when AL ref -5 °C was not measured for the set Al residence time at the AL
sensor.
15
15


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Sorel TC at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Sorel TC in the language / languages: English as an attachment in your email.

The manual is 2.51 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Sorel TC

Sorel TC User Manual - German - 16 pages

Sorel TC User Manual - Dutch - 16 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info