812407
1
Zoom out
Zoom in
Previous page
1/2
Next page
Room Sensor Clima 1-Wire
Digital room temperature and humidity sensor with communication via 1-wire bus in combination with °CALEONbox.
Technical Data
Power Supply 3,3 VDC ... 5 VDC SELV or PELV
Measurement Range 0 °C ... 60 °C / 0% ... 100%
Accuracy: +/- 1 °C / +/- 6 %
Resolution: 0,1 °C / 0,1 %
Protection Class IP20
Max. Cable Length up to 100 m powered (three-wire connection recommended),
up to 50 m parasitic (two-wire connection),
using twisted pair cables
Dimension 95 mm x 75 mm x 19 mm
Housing Design white plastic housing RAL 9003
Installation Methods wall Installation
Wall Installation
Mount the sensor in a suitable location.
Pay attention to suitable environmental conditions. Direct
sunlight, sources of heat and cold, e.g. radiators and win-
dows must be avoided.
Direct Wall Mounting
Hold the base and mark the 2 fixing holes required. Ensure that the
wall surface is as flat as possible. Drill holes in the wall and press in
the dowels (6 bit). Insert screws (3,5 x 30) and lightly tighten. Align the
base and tighten the screws.
Mounting on Plastic Wall Socket
Fix the base with the screws (3,0 x 16) to the mounting box.
Type Plate and Sticker with 1-Wire ID
Each sensor has a unique 16-digit 1-Wire ID. This ID is required for
sensor-room assignment in the °CALEON Room Controller. The ID
can be found inside the sensor on the type plate and on the supplied
sticker. To simplify the later configuration of the system, we recom-
mend to place the sticker in the table of the °CALEONbox operating
instructions or on the °CALEONbox terminal diagram sticker.
Electrical Connection
One of the terminal points VDD/DQ/GND is required for the connection
of a sensor. The additional three clamping points are for the easy con-
nection of further sensors.
Only to be used with SELV or PELV protective extra-low
voltage.
Open the terminals with the accompanying tool (°CALEON) and make
the electrical connection as described below.
If shielded cables are used, contact between the shielding
and the PCB can cause damage to the device and lead to
malfunctions.
SOREL GmbH Mikroelektronik | Reme-Str. 12 | D - 58300 Wetter (Ruhr) | +49 (0)2335 682 77 0 | +49 (0)2335 682 77 10 | info@sorel.de | www.sorel.de
1
1


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Sorel Room Sensor Clima 1-Wire - On Wall at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Sorel Room Sensor Clima 1-Wire - On Wall in the language / languages: English as an attachment in your email.

The manual is 0.89 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Sorel Room Sensor Clima 1-Wire - On Wall

Sorel Room Sensor Clima 1-Wire - On Wall User Manual - German - 2 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info