37274
56
Zoom out
Zoom in
Previous page
1/60
Next page
56
Symptom
The tape is ejected after being loaded.
The tape does not move.
The sound is not heard.
Recording cannot be made.
The 0OPEN/CLOSE does not function.
The sound is not heard from the recorded
tape.
The CAUTION indicator lights, and no
button does function.
Troubleshooting Guide
Cause
The cassette is inserted incorrectly.
For 4 seconds after the power is turned on,
the buttons do not function.
The 8PAUSE button is activated. (The 8
indicator lights.)
The tape is wound completely.
Incorrect connections.
Incorrect operation of the connected
amplifier.
The safety tab of the cassette is open.
Incorrect position of the INPUT selector.
The digital copy prohibit signal exists in the
source signal input to the digital input jack.
The 0OPEN/CLOSE does not function
during recording.
When recording analog input signals, the
recording level is turned down completely.
(When recording the analog input signal)
Moisture condenses inside the unit.
Defective or damaged cassette is inserted.
The cassette is removed forcibly from the
cassette compartment.
Remedy
Insert the cassette correctly. (page 18)
Wait until the blinking of the 8 indicator
goes off and then try again.
Press the 8PAUSE button to release pause.
Press the 1 or 4 button to rewind.
Connect properly. (pages 15 to 17)
Operate the amplifier as required by the
deck operation. (Refer to the operating
instructions of the amplifier.)
Close the tab of the cassette. (page 18)
Set the INPUT selector correctly.
When recording sound from the equipment
connected to the COAXIAL IN or OPTICAL
IN jack, set the INPUT selector to the
COAXIAL or OPT position respectively.
When recording sound from the equipment
connected to the LINE IN jacks, set to the
ANALOG position.
Connect the source equipment to the LINE
IN jacks.
Press 7 to stop recording and then press
0OPEN/CLOSE.
Adjust the recording level by using the
REC LEVEL control. (page 23)
Leave the unit turned on for about an hour.
(page 4)
Remove the cassette.
Turn off the unit and then turn on again.
Basic Operation
56


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Sony DTC630 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Sony DTC630 in the language / languages: English as an attachment in your email.

The manual is 0,51 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info