158453
3
Zoom out
Zoom in
Previous page
1/623
Next page
GB
3
Precautions
On safety
Should any solid object or liquid fall
into the cabinet, unplug the recorder
and have it checked by qualified
personnel before operating it any
further.
When disconnecting the mains
leads, do not touch the metallic part
of the jacks or plugs.
About the hard disk drive
The hard disk has a high storage
density, which enables long
recording durations and quick
access to the written data. However,
it can easily be damaged by shock,
vibration or dust, and should be kept
away from magnets. To avoid losing
important data, observe the
following precautions.
Do not apply a strong shock to the
recorder.
Do not place the recorder in a
location subject to mechanical
vibrations or in an unstable
location.
Do not place the recorder on top of
a hot surface, such as a VCR or
amplifier (receiver).
Do not use the recorder in a place
subject to extreme changes in
temperature (temperature gradient
less than 10 °C/hour).
Do not move the recorder with its
mains lead connected.
Do not disconnect the mains lead
while the power is on.
When disconnecting the mains
lead, turn off the power and
make sure that the hard disk
drive is not operating (the clock
is displayed in the front panel
display for at least 30 seconds
and all recording or dubbing has
stopped).
Do not move the recorder for
one minute after you have
unplugged the mains lead.
Do not attempt to replace or
upgrade the hard disk by yourself,
as this may result in malfunction.
If the hard disk drive should
malfunction, you cannot recover lost
data. The hard disk drive is only a
temporary storage space.
About repairing the hard disk
drive
The contents of the hard disk drive
may be checked in case of repair
or inspection during a malfunction
or modification. However, the
contents will not be backed up or
saved by Sony.
If the hard disk needs to be
formatted or replaced, it will be
done at the discretion of Sony. All
contents of the hard disk drive will
be erased, including contents that
violate copyright laws.
On power sources
The system is not disconnected
from the AC power source (mains)
as long as it is connected to the
wall outlet, even if the system
itself has been turned off.
If you are not going to use the
system for a long time, be sure to
disconnect the system from the
wall outlet. To disconnect the AC
power cord (mains lead), grasp the
plug itself; never pull the cord.
Before disconnecting the AC
power cord (mains lead), check
that the recorder’s hard disk is not
operating (recording or dubbing)
on the front panel display.
On placement
Place the recorder in a location
with adequate ventilation to
prevent heat build-up in the
system.
At high volume, over long periods
of time, the cabinet becomes hot to
touch. This is not a malfunction.
However, touching the cabinet
should be avoided. Do not place
the system in a confined space
where ventilation is poor as this
may cause overheating.
Do not block the ventilation holes
for the cooling fan by putting
anything on the system. The
system is equipped with a high
power amplifier. If the ventilation
holes are blocked, the system can
overheat and malfunction.
Do not place the system on a soft
surface such as a rug that might
block the ventilation holes.
Do not place the system in a
confined space such as a bookshelf
or similar unit.
Do not place the system in a
location near heat sources, or in a
place subject to direct sunlight,
excessive dust, or mechanical
shock.
Do not place the system in an
inclined position. It is designed to
be operated in a horizontal
position only.
Keep the recorder and discs away
from equipment with strong
magnets, such as microwave
ovens, or large loudspeakers.
Do not put any objects on the
recorder as they may fall, damage
the surface, or cause malfunction.
If the system is brought directly
from a cold to a warm location,
moisture may condense inside the
system and cause damage to the
lenses. When you first install the
system, or when you move it from
a cold to a warm location, wait for
about 30 minutes before operating
the system.
On recording
Make trial recordings before making
the actual recording.
On compensation for lost
recordings
Sony is not liable and will not
compensate for any lost recordings
or relevant losses, including when
recordings are not made due to
reasons including recorder failure,
or when the contents of a recording
are lost or damaged as a result of
recorder failure or repair undertaken
to the recorder. Sony will not
restore, recover, or replicate the
recorded contents under any
circumstances.
,continued
GB
3


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Sony dar-x 1 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Sony dar-x 1 in the language / languages: English, Polish, Swedish, Spanish, Spanish as an attachment in your email.

The manual is 59 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Sony dar-x 1

Sony dar-x 1 User Manual - German, Dutch, French, Italian - 639 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info