700030
3
Zoom out
Zoom in
Previous page
1/4
Next page
3
5. Slide the speaker onto the bracket and firmly snap into place
at the top and bottom of speaker. Pull enough wire through the
front of the speaker to allow connection to the terminals (see
figure 7).
6. Connect the speaker wires to the speaker’s terminals:
• Strip about .5” of insulation from each conductor and twist the
strands together or tin them with solder.
• Press-down on the tops of the connectors to open them.
• Insert the wires into the connector holes(see figure 8).
• Release the connectors.
The binding post connectors can accept wire up to 14 gauge.
Double-check that you connected all of the wires properly
(amplifier ‘+’ to speaker ‘+’; amplifier ‘–’ to speaker ‘–’) at
all connections.
Figure 7: Attach Speakers to Brackets
Figure 8: Connection Terminals
7. Fit the wiring connector cover into the recess in the speaker’s
front panel. The cover should fit tightly, but can be removed if
the speaker needs to be disconnected (see figure 9).
8. Fit the grille onto the speaker by aligning the edges of the grille
with the groove of the speaker face perimeter and pressing
firmly until it is snugly in place (see figure 10). Start by inserting
and pressing along the long edge, then insert one of the short
edges. Continue with the other long edge, and finally the other
short edge.
Figure 9: Attach the
Connector Cover
Figure 10: Attach the
Grille
UNLOCK (towards rear of speaker)
LOCK (towards front of speaker)
Figure 11: Lock and Unlock Slide Locks to Pivot Speaker
NOTE: ALL SONOS OUTDOOR BY SONANCE SPEAKERS ARE COMPATIBLE WITH OMNIMOUNT STAINLESS
STEEL 15.0 C AND 15.0 W SERIES SPEAKER BRACKETS. FOR MORE INFORMATION CONTACT YOUR
SONOS AUTHORIZED DEALER OR GO TO WWW.OMNIMOUNT.COM.
Pivoting the Speaker
You can rotate the speaker in the bracket to direct the sound
towards the listening area.
1. Unlock the slide locks on the speaker pivots by moving them
towards the rear of the speaker as indicated by the unlock
symbol (see figure 11).
2. Rotate the speakers to the desired position.
3. Lock the slide locks by moving them towards the front of
the speaker as indicated by the lock symbol (see figure 11).
NOTE: BE SURE THAT THE BRACKET CLIPS SNAP COMPLETELY INTO PLACE TO PREVENT ANY
BLOCKAGE WITHIN THE SPEAKER PERIMETER WHERE THE GRILLE IS TO BE INSERTED. PULL THE
SPEAKER GENTLY TOWARD YOURSELF TO VERIFY THAT IT IS SECURELY IN PLACE.
Removing the Speaker
To remove the speaker from the FastMount bracket, gently pull
the grille from each corner until it is freed from the grooves of
the speaker face. Once the grille is removed, remove the wire
connector cover and disconnect the speaker wire from the spring
loaded terminals. Next, use your thumbs to press outward on the
top and bottom tabs of the speaker face, releasing the clips of
the bracket. While pressing the tabs, pull gently on the speaker
away from the bracket.
IMPORTANT: BE SURE NOT TO LET ANY STRAY ‘+’ AND ‘–’ WIRES TOUCH EACH OTHER. TOUCHING
WIRES CAN CAUSE A SHORT-CIRCUIT THAT COULD DAMAGE YOUR AMPLIFIER.
Unlocking SONOS Audio
Enhancements
SONOS OUTDOOR by SONANCE speakers include exclusive
audio enhancements when used with a SONOS Amp. Use the free
SONOS app to unlock them.
Audio enhancements include:
Custom EQ settings
Gain adjustment
Dynamic bass extension
Signal limiting/loudspeaker protection
3


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Sonos OUTDOOR - BY SONANCE at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Sonos OUTDOOR - BY SONANCE in the language / languages: English as an attachment in your email.

The manual is 1,65 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info