771661
1
Zoom out
Zoom in
Previous page
1/2
Next page
HA360BU SONICBRIDGE / LAMP SWITCH
The HomeAware™ SonicBridge™ module HA360BU
allows traditional Sonic Alert receivers to work with the
new HomeAware™ D-RF Securesystem. The
HomeAware™ is the only wireless system available
that is compatible with all Sonic Alert remote receivers
including the SA101, SA201, BL300, RH100 and
SB1000 alarm clock. It also has the added feature of
allowing a lamp to be plugged into it to allow for a
flashing lamp option. To install the SonicBridge™
follow the four steps below.
1. Simply plug the SonicBridge™ into any 120v outlet
(do not plug into extension cords, power strips or
surge protectors) must be plugged directly into the
outlet for the best receiver reception.
2. Plug the opposite end into the back of the
HomeAware™ Main unit where it says Lamp SW.
3. You are now connected to the home power line
which will allow the HomeAware™ to communicate
with your traditional Sonic Alert remote receivers.
4. If you would like to utilize the option of a flashing
lamp for your alerts simply plug any lamp into the
SonicBridge™ and turn the lamp switch to the on
position. Your lamp can now be turned on and off
through the HomeAware Main unit by pressing
the snooze button for on and off.
Important notes for lamp bulb type
Lamp light bulb must not exceed 300 watts. Also make
sure the lamp is in the on position and that the bulb is a
good bulb.
Bulb types to use in lamps are as follows;
Incandescent, LED, and instant on CFL type bulbs
must be used.
FCC Requirements
This device complies with part 15 of the FCC rules, and
with RSS-210 of Industry Canada. Operation is subject
to the following two conditions; (1) This device might
not cause harmful interference, and (2) this device
must accept any interference received, including
interference that may cause undesired operation.
Note: This equipment has been tested and found to
comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC rules. These limits are
designed to provide responsible protect against harmful
interference in a residential installation. This
equipment generates, uses, and can radiate radio
frequency energy and, if not installed and used in
accordance with the instructions manual, may cause
harmful interference to radio communications.
However, there is no guarantee that interference will
not interfere in a particular installation. If this equipment
does cause harmful interference to radio or television
reception, which can be determined by turning the
equipment on and off, the user is encouraged to thy to
correct the interference by one or more of the following
measures:
i. Reorient or relocate the receiving antenna.
ii. Increase the separation between the
equipment and receiver.
iii. Connect the equipment into an outlet on a
circuit different from that to which the receiver
is connected.
iv. Consult the dealer or and experienced radio/
TV technician for help
Modification not expressly approved by the
manufacturer could void the user’s authority to operate
the equipment under FCC rules
1


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Sonic Alert HA360BU at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Sonic Alert HA360BU in the language / languages: English as an attachment in your email.

The manual is 0.09 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info