680772
35
Zoom out
Zoom in
Previous page
1/36
Next page
Help in case of malfunction
34
Fault Possible cause Remedy
Operator does not close door
Operator opens the door, then there is no
more reaction on one command with key or
remote control transmitter
The drive closes the door; subsequently
no response to pressing of button or radio
transmitter
Opening or closing speed varies
Operator does not terminate “Learn”
sequence.
“Start” LED is continuously on
Radio receiver only!!
All LEDs are flashing
LED 3.1 or 3.2 is continuously on
LED 3.1 or 3.2 is continuously on
Traffic lights not working
Traffic light behaviour incorrect
Mains power photoelectric cell is
tripped
Power supply to photoelectric cell
interrupted
Permanent signal on button input 1/2
or radio channel 1/2. Start LED lights
up.
Safety input tripped
(e.g. photocell defective)
Safety LED lights up
Totally normal
Door CLOSED limit switch in the trolley
defective
Door OPEN limit switch in the trolley
defective
Operator starts slowly and then picks
up speed
Chain rail is dirty
Chain rail has been lubricated with the
wrong oil
Chain tension incorrect
End positions set incorrectly
Continuous signal on button
connection 1 or 2
Permanent signal from radio receiver,
LEDs 3.1 or 3.2 on the radio receiver
light up. Radio signal is being received;
a remote control transmitter button
might be defective or an external signal
is received.
All memory slots are occupied
(max. 448 positions)
Radio signal is being received; a
remote control transmitter button might
be defective or an external signal is
received
Radio receiver is in “learning” mode
and expects a code signal from a
remote control device
Traffic light control not powered
(230 V AC)
Traffic light control fuse defective
Wrong drive control system
Four-wire control line connected
incorrectly; wires not or incorrectly
connected
Check connection
replace fuse
The first command issued after the mains supply has been restored
always has the operator fully open the door
– Connected button defective – replace
– Remote control transmitter defective or there is interference
– Timer connected
– Remove obstruction from photoelectric cell path
– Repair photoelectric cell
– Terminal bar is not connected correctly
Operator closes the door automatically, after expiration of the times
(hold open time, clearance time, and warning time)
Replace limit switch
Replace limit switch
Soft run” mode – completely normal.
Clean rail and re-lubricate,
see “Maintenance and Care” section
Clean rail and re-lubricate,
see “Maintenance and Care” section
Tension chain, see “Assembly”
Adjust end positions (see general instructions in “Commissioning”).
Check connected buttons (e.g. key-activated button, if connected)
– Remove battery from the remote control transmitter
– Wait until the external signal decays
– Delete the data of all radio control devices that are not in use
– Install additional radio receiver
– Remove battery from the remote control transmitter
– Wait until the external signal ceases
Press desired button on remote control transmitter
Repair power supply
Replace fuse
Traffic light control only works in conjunction with tiga control system
Check connections
35


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Sommer Marathon Tiga 800 SLX at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Sommer Marathon Tiga 800 SLX in the language / languages: English as an attachment in your email.

The manual is 3,87 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Sommer Marathon Tiga 800 SLX

Sommer Marathon Tiga 800 SLX User Manual - German - 38 pages

Sommer Marathon Tiga 800 SLX User Manual - Dutch - 38 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info