663505

Solis 112 - OhEspresso Manual

18
Zoom out
Zoom in
Previous page
1/20
Next page
18
Descaling instructions :
5.1 Turn machine on and heat up.
5.2 Add 2 Solis descaling tablets and
½ litre of
lukewarm water to the water tank.
Important: Please remove the water
filter BRITA from the water tank. Leave to
stand for approx. 15 minutes until the tablets
have dissolved completely.
5.3 Insert the descaling seal into the top oft he
coffee portion slot (Fig.7). The seal should
remain inserted in the machine throughout
the descaling and rinsing process.
5.4 Place a container under the coffee outlet.
5.5 Briefly turn the coffee selector (4) to the
coffee position and turn the coffee selector
back to the position 0 when approx. 1 dl
water is in the container. Leave machine to
stand like this for approx. 10 minutes.
Important: The descaling solution must
flow from the «Coffee outlet» (7). Should
this not be the case, carefully re-position the
descaling seal (Fig. 7).
5.6 Repeat this procedure 3 times.
5.7 Rinse out water tank.
5.8 Fill water tank half full with cold water and
place in position.
5.9 Turn the coffee selector (4) to position I until
the water tank is empty.
If the pump stopps operating during the
rinsing cycle, turn the Coffee selector switch
(4) to position «0» and then again to position
«Coffee». The pump will restart.
5.10 Turn the coffee selector (4) back to position 0.
5.11 Pull descaling seal upwards and clean.
5.12 Replace the water filter BRITA in the water
tank, Fill the water tank with fresh water.
Machine is now ready to use again.
6. Faults and possible
causes
Please read the following points carefully before
sending in your appliance for repair. You will often
find you are able to resolve the problem yourself,
saving yourself trouble and inconvenience.
6.1 Coffee is not hot
enough :
– Wait for the green operating temperature
indicator to come on.
– Cup ist too cold: Pre-heat.
6.2 No coffee comes out of the machine:
– No water in the tank
– The water tank is not properly inserted.
6.3 The appliance will not switch on:
– Appliance is not properly connected to power
supply/check fuse.
– Brewing unit cover is not shut properly.
6.4 Water pump makes a loud noise:
– Not enough water in the tank
6.5 The pod is not ejected:
– Clean the brewing unit shown on point 4,
«Care and cleaning»
– Check that the coffee waste container is
empty
If you cannot resolve the problem after checking
these points please return the appliance in its
original packaging, with details of the defect, to our
Customer Service Unit or approved Service Center.
7. Disposal of appliance
EU 2002/96/EC
Disposal:
In conformity with Directive 2002/96/EC
on waste electrical and electronic equipment
(WEEE), at the end of its life the unit should be
taken to an electrical appliance collection point for
its environmentally friendly disposal.
E
Fig. 7
Anleitung_oh_espresso.indd 18 9.1.2008 10:02:12 Uhr
… 18


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Solis 112 - OhEspresso at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Solis 112 - OhEspresso in the language / languages: English, German, French, Italian as an attachment in your email.

The manual is 2,33 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info