Manual Smeg KSET 900 (page 5 of 6) (English)

109380

Zoom out

Zoom in

1/6

outlet in conformity with local standards in force.

Where an electrical plug is not provided (for direct

connection to electrical network) place a standards approved

bipolar switch with an aperture distance of not less than

3mm (accessible) from the contacts.

Mounting the Hood

The diameter of the ventilation duct must be the same as

the that of the flange mounted on the ventilation hole on the

hood.

To mount the hood proceed as follows:

— Position the drilling template inside the left cupboard

on the right hand side with the arrow point towards

the back on the cupboard (Fig. 8)

— Drill the holes marked on the template (Fig. 8)

— Repeat the procedure for the right hand cupboard

— If the sides of the cupboards are 18 mm thick, insert

4 spacers M on the sides of the hood (Fig. 9)

— Fix the hood to the cupboard using four screws N

(Fig. 9).

Adjusting the Pull-Out Drawer

The hood can be installed beneath cabinets with varying

depths. Adjustments for opening and closing the drawer

can be made based on your specific needs.

To adjust the drawer, remove the ventilation grates by

loosening the O screws and adjusting the P brackets. Then

retighten the O screws (Fig. 10).

Using the hood

The hood is provided with several speeds.

For the best performance, we recommend using the low

speeds in normal conditions and the high speeds when

strong odour and vapour concentrations are present.

We recommend starting the hood a few minutes before

cooking and keeping it running for at least 15 minutes until

all the odours have been eliminated.

Maintenance

Caution! Before performing any maintenance,

disconnect the hood from the electrical supply.

Grease Filter

The grease filter serves to trap grease particles by

suspending them.

1. Synthetic Filter (thickness: 10-15 mm): wash the

filter in warm water and a biodegradable detergent

once a month. Let dry without wringing. Replace after

the filter has been washed 5 or 6 times.

2. Thin Synthetic Filter (approximately 1 mm thick):

replace when the coloring from the top is visible on the

bottom part.

3. Thin Synthetic Filter (approximately 1 mm thick -

without saturation indicator) replace every two months.

4. Metal Filter: unlimited life; wash every month in

warm soapy water, or, if possible, in the dishwasher

(60°C). Let dry before reinstalling it.

Removing the Grease Filters (for models wtih grease

filter support grates)

To remove the dirty grease filter, proceed as follows:

a. Remove the pull-out drawer completely and open the

ventilation grates that support the grease filters.

b. Remove the Q fasteners for the grease filter and

remove it (Fig. 11.1). If special metal filters have been

installed, press on the plastic springs R to unhook them

(Fig. 11.2).

c. When washing or replacing the grease filter, wash the

grate as well with warm soapy water.

d. Remount the new filter or the old one after it has dried

thoroughly.

Charcoal Filter

The charcoal filter serves to eliminate odours that form

during the cooking process. Under normal use conditions,

the filter should be replaced every 4 months. It can be

ordered from the retailer. The charcoal filter must never be

washed.

To remove the charcoal filter, proceed as follows:

a. Remove the pull-out drawer.

b. Remove the grease filters and open the light cover

support (or the greas filter support grate).

c. Reverse the procedure described in item 1) or 2),

depending on the version, of the “Air recirculation”

paragraph.

Replacing the Lamp

a. Remove the pull-out drawer.

b. Open the light cover support or the back grease filter

support grate.

c. Always replace burnt-out lamps, according to what is

provided for your appliance, with olive-shaped max.

40 Watt (E 14) bulbs, or neon-lamp 14 Watt max., or

PL lamp 11 Watt (one PL lamp appliance) or PL 9 Watt

(two PL lamp appliance).

d. Close the light cover support or the back grease filter

support grate.

e. Before calling for customer service because the

lighting system does not work, make sure that the

lamps are screwed in tightly.

Cleaning

To clean the outside of the hood use a cloth moistened with

denatured alcohol or neutral liquid detergents. Never use

products containing abrasives.

Attention

Failure to observe the instructions for cleaning the appliance

and changing and cleaning the filters may cause fires.

Therefore, we recommend observing these instructions.

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Smeg KSET 900 in the language / languages: English as an attachment in your email.

The manual is 0,15 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Smeg KSET 900

Smeg KSET 900 User Manual - German, Dutch - 7 pages

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Smeg KSET 900 Manual

Product: