109379

Smeg KSEG 52 Manual

5
Zoom out
Zoom in
Previous page
1/8
Next page
10
Description of the hood - Fig. 1
1. Control panel
2. Air-inlet surface (with grease filter)
3. Lights
Use of the hood
The hood is fitted with a control panel with
aspiration speed selection control and a light
switch to control cooking area lights.
For the best performance, we recommend
using the low speeds in normal conditions and
the high speeds when strong odour and vapour
concentrations are present.
Light should be switched ON to improve cooking
area visibility.
It is advisable to switch on the extractor hood a
few minutes before starting cooking and then
to leave it running for approximately 5 minutes
afterwards to ensure that all odours are
extracted.
Maintenance
Before performing any maintenance operation,
isolate the hood from the electrical supply by
switching off at the connector and removing the
connector fuse.
Or if the appliance has been connected through
a plug and socket, then the plug must be
removed from the socket.
Metal grease filter
The grease filter serves to trap grease particles
present on cooking fumes.
The metal grease filter lasts forever and must
be washed either by hand or in the dishwasher
(65°C) with suitable detergents.
The grease filters must be washed at least
once a month.
When washed in a dishwasher, the metal grease
filter may discolour. It’s filtering properties will
nevertheless remain unaltered.
Let the filter dry without damaging it before
putting it back into place.
To remove the metal grease filter
(according model you own:Fig. 2-a-b-c-d)
1. Disconnect the hood from the electricity.
2. Push handles A toward the centre
The model with the grill support (see fig. 2d)
has an internal metal filter.
The release the grease filter support from the
hood, pull the release buttons B (Fig. 3) inwards.
To extract the metal grease filter from the
support grill, pull from right to left and extract
the grease filter.
GB
(When washing the grease filter, wash the
support grate as well with warm soapy water).
Carry out the above steps in reverse order to
put the filters back after having washed them,
making sure the entire extraction surface is
covered.
Carbon filter - Fig. 4
(Recirculation mode only)
The carbon filter serves to eliminate odours
that form during the cooking process.
The carbon filter cannot be washed nor
regenerated.
The carbon filter should be replaced every 6
months under normal use.
To dismount the carbon filter:
1. Disconnect the hood from the electricity.
2. Remove the metal filters (or its support).
3. Remove exhausted carbon filter, push
release button C and pull carbon filter
downwards.
To fit the carbon filter:
1. Fit the carbon filter by sliding it OVER the
metal tabs D and hook it into housings E.
Put the metal filter or its support back into
place.
Cleaning
To clean the outside of the hood use a cloth
moistened with denatured alcohol or neutral
liquid detergents. Never use products
containing abrasive.
Wipe brushed stainless steel in the same
direction as the brushing to avoid scratching.
Clean the external surface of the cooker hood
almost once every 10 days.
Attention
Failure to observe the instructions for cleaning
the appliance and changing and cleaning the
filters may cause fires.
Therefore, we recommend observing these
instructions.
Replacing the lamp - Fig. 4
1. Disconnect the hood from the electricity.
2. Open the lamp holder compartment by
turning the clasps F for the protective shield
for the lamps in the counter-clockwise
direction.
3. Replace faulty lamp with one of an equal
rating and kind.
5


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Smeg KSEG 52 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Smeg KSEG 52 in the language / languages: English as an attachment in your email.

The manual is 0,13 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Smeg KSEG 52

Smeg KSEG 52 User Manual - German - 8 pages

Smeg KSEG 52 User Manual - Dutch - 7 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info