570580

Singer 29K71 Manual

11
Zoom out
Zoom in
Previous page
1/13
Next page
10 REGULATE PRESSURE ON THE
MATERIAL
The pressure on the material is regulated by knurled
thumbnut O, Fig. 31. To increase the pressure, tighten the
thumbnut. To reduce the pressure, loosen the "
Thumb nut.
Heavier pressure is required for leatherwork than for
sewing cloth or cotton materials. The pressure should be
only heavy enough to enable the feed to move the work
along evenly.
Fig. 31. Regulating Pressure on Material
TO TURN A CORNER
Stop the machine with the needle in the work and turn top
of hand wheel over toward you until the feeding foot rises.
Then turn the work as desired, using the needle as a pivot.
NOTE: If hand wheel is located on front of machine, turn
top of hand wheel over to the right.
TO REGULATE THE AUTOMATIC LIFT
OF THE FEEDING FOOT
While the machine is in operation, the feeding foot rises
after it has moved the work forward; then the foot moves
toward the needle and descends again upon the fabric. It is
advisable that the lift of the foot should be only sufficient
to clear the thickest part of the work.
To adjust the lift, raise the feeding foot by means of lifter
B, Fig. 31. To increase the feeding foot lift, loosen wing
screw N and move the screw toward you. To reduce the
lift, move the screw away from you. When the desired
height of lift is obtained, tighten the wing screw.
TO CHANGE DIRECTION Of THE FEED
While stitching, the work is moved along by the action of
the feeding foot only.
The direction of the stitching can be changed as desired by
turning the foot around by means of the two handles E,
Fig. 32.
Fig. 32. Changing Feed Direction
TO CHANGE THE NEEDLE PLATE
1. Raise the needle bar to its highest position.
2. Loosen screw Q, Fig. 33 and, by lifting upward,
remove needle plate and hinge pin P.
3. When replacing the needle plate, place flat side of pin P
toward screw Q.
4. Tighten screw Q on flat side of pin P.
Fig. 33. Correct Position of Hinge Pin in Needle Plate
11
… 11


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Singer 29K71 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Singer 29K71 in the language / languages: English as an attachment in your email.

The manual is 0,49 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info