300340
12
Zoom out
Zoom in
Previous page
1/16
Next page
Lombok A150/A150A/A250/A250A / UK-IE / A31008-M2702-L101-1-7619 / Lombok.fm / 22.08.2016
Version 4, 16.09.2005
12
Appendix
Entering letters/characters
Specifications
Batteries
Technology: Nickel-metal-hydride (NiMH); Size: AAA (Micro, HR03); Voltage: 1.2 V;
Capacity: 400 - 1000 mAh
General specifications
Standard
char
acters
Press the relevant key
the number of times
indicated.
Briefly press the hash
ke
y
# to switch from
"Abc" to "123" mode,
from "123" to "abc"
mode and from "abc"
to "Abc" mode.
1) Space
1x 2x 3x 4x 5x 6x 7x 8x 9x 10x 11x 12x 13x 14x 15x
1
1£$¥¤
2
abc2äáàâãç
I
def 3ëéèê
4
gh i4ïíìî
5
jkl5
L
mno6öñóòôõ
M
pqr s
N
tuv8üúùû
O
wx y z 9ÿýæøå
Q
.,?!0+-:¿¡"’;_
P
*/()<=>%
#
#@\&§
1)
DECT standard is supported
GAP standard is supported
Range up to 300 m outdoors, up to 50 m indoors
Radio frequency range 1880-1900 MHz
Transmission power 10 mW average power per channel, 250 mW
pul
se power
Base station power supply 230 V ~/50 Hz
Environmental conditions
in operation
+5 °C to +45 °C, 20% to 75% relative humidity
Base station power consumption A150/A250 A150A/A250A
In standby mode
– Handset in base station
– Handset outside base station
ca. 1.0 W ca. 1.2 W
ca. 0.8 W ca. 1.0 W
During a call ca. 1.0 W ca. 1.2 W
Questions and answers
If you have any queries about the use of your telephone, visit our website at
www.gigaset.com/service for 24-hour support. The table below contains a list of com-
mon problems and possible solutions.
Contact with liquid
If the device comes into contact with liquid:
1 Disconnect the power supply.
2 Remove the batteries and leave the battery compartment open.
3 Allow the liquid to drain from the device.
4Pat all parts dry.
5 Place the device in a dry, warm place for at least 72 hours (not in a microwave,
ov
en etc.) with the battery compartment open and the keypad facing down (if ap-
plicable).
6 Do not switch on the device again until it is completely dry.
When it has fully dried out, you will normaly be able to use it again.
Problem Cause Solution
Nothing
ap
pears in
the display.
The handset is not switched
on.
The batteries are flat.
Press the end call key a for approx.
5 seconds or place the handset in
the
base station.
Charge or replace the batteries.
No wireless
c
onnection
to the base
sta
tion,
Base flashes in
th
e display.
The handset is outside the
r
ange of the base station.
The handset is not regis-
tered.
The base station is not
tur
ned on.
Move the handset closer to the base
station.
Register the handset
¢ page 9.
Check the mains connector on the
ba
se station
¢ page 4.
You cannot
hear a ringe
r/
dialling tone
from the fixed
line network.
The phone cord supplied
has n
ot been used or has
been replaced by a new cord
with the wrong jack connec-
tions.
Please always use the phone cord
su
pplied or ensure that the
pin connections are correct when
p
urchasing from a retailer: 3-4
assignment of telephone leads/
EURO CTR37.
Error tone
sounds
after
system PIN
prompt.
PIN forgotten.
The system PIN you have
enter
ed is incorrect.
Reset the system PIN to the default
0000
¢ page 11.
All handsets are de-registered. All
s
ettings are reset. All lists are
deleted.
!
12


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Siemens gigaset a150 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Siemens gigaset a150 in the language / languages: English as an attachment in your email.

The manual is 0,57 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Siemens gigaset a150

Siemens gigaset a150 User Manual - German - 16 pages

Siemens gigaset a150 User Manual - Dutch - 19 pages

Siemens gigaset a150 User Manual - French - 19 pages

Siemens gigaset a150 User Manual - Italian - 16 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info