299001
17
Zoom out
Zoom in
Previous page
1/19
Next page
15
Remote control, data transfer
Temporary swithover of the signaling method
If your telephone is connected to an exchange with pulse dialing (pulse), you
must temporarily swith your phone over to dual-tone multi-frequency
signaling (DTMF), as described below, in order to operate a device such as an
answering machine by remote control or to perform a data transfer.
Conduct a call
Press the * key
You can now enter the appropriate numbers for the services.
At the end of the call,
the telephone switches back to pulse the dialing.
Notes:
You should not use the “switchover of the signaling method” procedure when
switching over to DTMF signaling temporarily. Since this will switch over the
signaling method permanently (see section on “Basic settings: Setting the
signaling method” on page 6).
Only the digits entered before switchover are dialed during last number redial.
17


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Siemens euroset 812 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Siemens euroset 812 in the language / languages: English as an attachment in your email.

The manual is 0,39 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info