647071
20
Zoom out
Zoom in
Previous page
1/22
Next page
en
20
Eliminating minor faults yourself
Before you call customer service:
Please check whether you can eliminate the fault yourself based on the following information.
Customer service will charge you for advice – even if the appliance is still under guarantee!
Appliance
Ice maker
Fault Possible cause Remedial action
Appliance has no refrigeration capacity.
The light does not work.
The display does not illuminate.
Appliance has been switched off. Press the On/Off button.
Power failure. Check whether the power is on.
The fuse has been switched off. Check the fuse.
The mains plug has not been inserted properly. Check whether the mains plug is secure.
The refrigeration unit is switching on
more frequently and for longer.
Appliance opened frequently. Do not open the appliance unnecessarily.
The ventilation openings have been covered. Remove obstacles.
Large quantities of fresh food are placed
in the freezer.
Activate “super” cooling and/or “super” freezing.
The light (LED) does not work. The LED lamp is defective. Call customer service.
Light switch is jammed. Check whether it can be moved.
Display indicates “E..”. Electronics have detected a fault. Call customer service.
Display indicates “LOWPOWER”. The mains voltage falls below the permitted
limiting value.
When the mains voltage reaches the stipulated value
again, the warning message goes out. If the warning
message lasts for longer, inform the energy supply
company.
Display indicates “HIGHVOLT”. The mains voltage exceeds the permitted
limiting value.
When the mains voltage reaches the stipulated value
again, the warning message goes out. If the warning
message lasts for longer, inform the energy supply
company.
Condensation forms on the rail on
the left door.
Condensation of warm air. Switch on heater in the rail (see chapter “Special
functions”, section “Door rail heater”).
Fault Possible cause Remedial action
The ice maker doesn’t work. Ice maker is not connected to the mains supply. Call customer service.
Ice maker does not contain any fresh water. Ensure that the water is properly connected.
The freezer compartment temperature is too
warm.
Check freezer compartment temperature and, if
required, set slightly colder.
The ice maker does not make enough
ice or the ice is deformed.
The appliance or ice maker has only just been
switched on.
Approx. 24 hours is needed until ice production starts.
A lot of ice has been taken. Approx. 24 hours is needed until the ice cube container
is filled again.
Low water pressure. Connect the appliance to the stipulated water pressure
only (see chapter “Connecting the appliance”, section
“Water connection”).
The water filter is bunged up or used. Change the water filter.
Temperature in the freezer compartment is too
warm.
Set temperature slightly colder in the freezer
compartment.
Ice cubes have accumulated on the rear panel of
the ice cube container.
Distribute ice cubes in the ice cube container. If ice
cubes are stuck to each other, loosen with a blunt
implement.
20


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Siemens CI24RP01 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Siemens CI24RP01 in the language / languages: English as an attachment in your email.

The manual is 3,01 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Siemens CI24RP01

Siemens CI24RP01 User Manual - German - 22 pages

Siemens CI24RP01 User Manual - Dutch - 23 pages

Siemens CI24RP01 User Manual - French - 25 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info