480345
3
Zoom out
Zoom in
Previous page
1/116
Next page
3
GB
E
I
F
P
GR
D
NL
PL
H
RO
CZ
SK
LT
LV
EST
SLO
UA
BG
WARNING
Do not install the refrigerator in a damp or wet
location as this may cause damage to the
insulation and a leak. Condensation may also
build on the outer cabinet and cause rust.
1
Keep adequa
t
e ventilation space around the
refrigerator.
The figure shows the minimum required space for
installing the refrigerator. It differs from the space in
the measurement condition of the amount of power
consumption.
It is possible to use the refrigerator with a less amount
of power consumption by keeping greater space.
If using the refrigerator in the space below dimension
of the figure, it may cause the temperatures in the unit
to rise, loud noise, and failure.
2
Using the two front adjustable feet, ensure that the
refrigerator is positioned firmly and level on the floor.
3
Remove the 2 screws of the cabinet lower part, and
use these to fit the foot covers. (supplied inside the
refrigerator compartment)
NOTE
Position your refrigerator so that the plug is accessible.
Keep your refrigerator out of direct sunlight.
Do not place next to heat generating appliance.
Do not place directly on the ground.
Provide suitable stand.
When transporting
Using the casters, it is possible to move back and forth.
Carry the refrigerator by holding the handles located on
the rear and bottom.
Before using your refrigerator
Clean the inside parts with a cloth soaked in warm water.
If soapy water is used, wipe it off thoroughly with water.
This refrigerator is provided with a indicator of temperature
in the refrigerator compartment to allow you to control the
average temperature in the coldest zone.
Coldest zone
The symbol indicates the coldest zone in the
refrigerator compartment. (The door pocket
positioned at the same height as the symbol
isn’t the coldest zone.)
Checking the temperature in the
coldest zone
You can carry out regular checks to ensure the
temperature in the coldest zone is correct and, if
necessary, adjust the refrigerator temp. control.
To maintain a correct temperature inside the appliance,
check that the indicator of temperature is always BLUE.
If the indicator of temperature turns WHITE, the
temperature is too high; in this case, increase the
refrigerator temp. control setting and wait for 6 hours
before checking the indicator of temperature again.
NOTE
The internal temperature of the refrigerator depends on
various factors such as the ambient temperature of the
room, the amount of food stored and the frequency of door
opening.
When fresh food has been introduced or the door has been
left open for some time, it is normal for the indicator of
temperature to turn WHITE.
INSTALLATION
60 mm
or more
60 mm
or more
90 mm
or more
a
a
SJ-PD591S
SJ-PD641S
SJ-PD691S
b
1400mm
1500mm
1230mm
1400mm
b
Foot cover
Adjustable foot
2 pcs.
4 pcs.
SJ-PD591S :
SJ-PD641S , SJ-PD691S :
INDICATOR OF
TEMPERATURE
Symbol
BLUE
WHITE
Correct setting
Temperature too high,
adjust the refrigerator temp.
control.
(B013)02-07_Eng.fm Page 3 Monday, June 29, 2009 10:07 AM
3


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Sharp SJ-PD641S at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Sharp SJ-PD641S in the language / languages: English, German, Dutch, French, Italian, Polish, Portuguese, Spanish as an attachment in your email.

The manual is 30,08 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info