735558

Senseair eSENSE Duct Disp Manual

3
Zoom out
Zoom in
Previous page
1/8
Next page
Document
IMA0215
Rev
7
Page
3 (8)
Mounting of eSENSE on to the duct.
10
10 Hole with 25 mm diameter
Figure 3 Mounting of the sensor to the ventilation duct
Mounting Instruction
Since there might be a substantial pressure difference in duct mounting applications,
it is essential to avoid ambient air from suction into the duct mounting box. For
correct function it is indispensable that the sealing of the box cover, the cable entry
bushings, the cable feed through and the duct entrance are absolutely tight. The duct
entrance may need extra sealing paste in order to prevent leakage. The PCB must
be handed carefully and protected from electrostatic discharge.
1) Place the O-ring around the hole at the back of the box. See figure 2.
2) Electrical cable entry: The box has a factory mounted cable entry bushing.
Never feed more than one cable through each cable entry bushing, or else gas
might leak through!
3) Mounting the tube: Drill a hole (10) with 25 mm diameter (or 1 inch) for the
sampling probe and two holes with 4 mm diameter for the screws (5) into the air
duct and mount the tube (1) with the gasket (2). The sampling probe should be
mounted with the largest locking knob on top. The unit can be mounted with the
air coming from the left or right.
4) Attaching the sensor box is made to the sampling probe by a snap-in bayonet
fitting. Orient the box onto the sampling probe so that the box upside is on the
same side as the largest locking knob (3). When the probe is fitted into the
notches of the box, then turn the box clockwise until stop (see Figure 2). Position
1 indicates open where the box can be removed from the sampling probe. In
position 2 the box is locked to the probe.
3


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Senseair eSENSE Duct Disp at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Senseair eSENSE Duct Disp in the language / languages: English as an attachment in your email.

The manual is 0,69 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info