Manual Sencor SPR 4000 (page 12 of 14) (English)

758983

Zoom out

Zoom in

1/14

- 12 - 06/2019

off and four dashes will be shown on the display. Now it is possible

to open the lid and add or remove ingredients, etc.

Note:

This function is available for the Stew, Meat and Soup

programs.

COOKING WITH AN OPEN LID

■ Rotate the handle A9 to symbol and open the lid using button

A3. The display will show “OPEN” and the unlocked lid indicator

B12 will be lit.

■

On the open lid, rotate the handle A9 towards the symbol . The

display will show four dashes and the unlocked lid indicator B12

will be lit.

■ Select acooking program using button B17 (Menu).

■

To set the temperature, press button B3 (Manual), then B7

(Temperature) and use buttons B6 (minus) and B18 (plus) to set

the desired value.

■ To set the time, press button B19 (Cooking Time) and use buttons

B6 (minus) and B18 (plus) to set the desired value.

■

Press button B15 (Start). The cooking process will start even with

the lid open.

DELAYED COOKING FUNCTION

■

The delayed cooking function enables you to start cooking at atime

of your choosing. The minimum delay time is 10 minutes and the

maximum delay time is 24 hours.

Note:

This function is not available for the programs FRY,

YOGHURT, DESSERTS and CAKE.

■

Select acooking program and press button B16 (Preset). The minutes

indicator will start flashing. Using buttons B6 (minus) and B18 (plus)

set the minute value for delayed cooking.

■ To set the hours, again press button B16 (Preset) and use buttons

B6 (minus) and B18 (plus) to set the hours value.

■

Press button B15 (Start) to start the countdown. Indicators B8

(Manual), B9 (Preset) and B10 (Countdown) will be lit. As soon as

the time you set elapses, the pressure cooker will start the cooking

process.

KEEP WARM FUNCTION

■

The Keep warm function will keep food warm at apreset temperature

for up to 24 hours.

■

The function will start automatically when the pressure cooker

finishes the cooking process. The display will show the time 00:00

and the timer will start counting up in minutes.

■

The function can be started at any time by pressing button B2

(Cancel/Keep warm).

TURNING OFF THE PRESSURE COOKER

■ To completely turn off the pressure cooker, disconnect the power

cord A15 from the power socket.

CLEANING AND MAINTENANCE

Attention:

Apart from the removable pot A10, no part of

the pressure cooker is intended to be washed in

adishwasher.

The pressure cooker unit A4 is not intended to be

washed under awater tap. Do not spray the pressure

cooker unit or the power cord with water or any

another liquid, or submerge it in water or another

liquid.

Attention:

Never use chemicals, cookware scrubbers, steel wool,

or abrasive cleaning agents to clean the outside of the

pressure cooker unit A4 or the inside of the inner pot

A11 as this could damage the surface of the pressure

cooker unit or the inner pot.

■

Before cleaning, always disconnect the power cord A15 of the

pressure cooker from the mains power supply and pull it out of

the socket of the pressure cooker. Before removing the lid A1 and

taking out the inner pot A10, always leave the pressure cooker to

cool down completely.

REMOVABLE INNER POT AND ACCESSORIES

■

Wash the removable inner pot A10 in hot water with detergent, rinse

it and dry it thoroughly. If there are baked on food remains inside the

inner pot, then first allow it to soak for 20-30minutes in hot water

with detergent. The food remains can then be easily removed using

asoft kitchen brush. The pot can also be washed in adishwasher.

Note:

The colour of the inside surface of the inner pot A10 may

change during use. This is normal and in no way changes

the properties of the surface.

■ Wash the accessories A16 to A19 in hot water with detergent, rinse

them and dry them thoroughly.

PRESSURE COOKER UNIT AND THE BUILT-IN OUTER POT

■ Clean the outer surface of the pressure cooker unit A4 using asoft,

damp cloth and wipe it dry using adry wiping cloth.

■

Wipe the inside of the built-in outer pot A11 with alightly dampened,

soft wiping cloth and then wipe it dry using adry, clean wiping cloth.

■

Wipe the display using asoft sponge lightly dampened in warm

water. Adry sponge or cleaning agents could scratch the surface.

■ Carefully pull out the water condensate tank G1. Wash it in warm

water with asmall amount of kitchen detergent. Rinse it with clean

water, wipe it dry and put it back in its place.

LID OF THE REMOVABLE POT

■

Pull on the steam valve cover C3 to remove the lid of the removable

pot out of the pressure cooker unit. Push the cover out of the hole

of the lid body C1.

■

Gently pull the gasket C2 around the entire perimeter to remove

it from the lid body.

■

Wash the lid body in hot water with standard detergent, remove any

food remains using afine brush, rinse with clean water and wipe it

dry. Carefully wash the gasket and the cover in warm water with

asmall amount of kitchen detergent. Rinse with clean water and

wipe thoroughly until dry. Return the gasket and the cover back in

their place in reverse sequence.

■

If the gasket or the cover are worn out or damaged, contact the

supplier, who will order the respective part for you.

INNER PARTS OF THE PRESSURE COOKER LID

■ After removing the lid of the removable pot, also clean the bottom

(inner) part of the pressure cooker lid. Clean the surfaces of the lid

using asoft damp cloth or suitable soft brush.

■ Check the valves D1, D2 and D3 and the temperature sensor D4 for

soiling and if necessary carefully clean these parts using asoft brush.

Carefully pull the gaskets off the valves D1 and D2 and wash them

in hot water with detergent, rinse and dry them thoroughly. Return

both gaskets to their place.

Attention:

Never use the pressure cooker without the float valve

gaskets or if the gaskets are damaged.

OUTER PARTS OF THE PRESSURE COOKER LID

■ Clean the outer parts of the pressure cooker lid using asoft, damp

cloth and wipe it dry using adry wiping cloth.

■ Pull upwards to remove the cover A8 and cover E1 of the outer part

of the steam release valve E2.

■ Use adamp wiping cloth to clean the contact surfaces of the cover

A8 including the hole E3. Use asoft brush to clean the outer parts of

the steam release valve E2 and dry it using adry wiping cloth. Slide

the cover E1 back on to the outer part of the valve.

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Sencor SPR 4000 in the language / languages: English as an attachment in your email.

The manual is 2,15 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Sencor SPR 4000 Manual

Product: