759955
6
Zoom out
Zoom in
Previous page
1/10
Next page
EN-6
EN
Electric Shaver
SMS 3011BL / SMS 3012GR / SMS 3013RD / SMS 3014TQ
Revision 02/2015
Copyright
©
2015, Fast ČR, a.s.
CHARGING THE ELECTRIC SHAVER
Charge, use and store the electric shaver at an ambient temperature of 5–35 °C.
Make sure that the switch A6 is set to the OFF position before charging the shaver. The electric
shaver can be charged from a power socket or via a computer equipped with an appropriate USB
interface.
Connect the electric shaver to a power source:
A. Connecting to a power socket
Connect one end of the USB cable Aqa to the power adapter A0, connect the other end to the USB
socket A9 on the underside of the electric shaver. Connect the power adapter A0 to an electrical
power socket (100–240 V).
B. Connecting to a computer
Connect one end of the USB cable Aqa to the USB socket A9 located on the underside of the
electric shaver and connect the other end to the computer.
After connecting the electric shaver to a functioning power source, the red LED charging indicator
A8 will be lit. A complete charge takes approximately 8 hours.
Note:
If you are charging the electric shaver for the first time or if you have not used it for a long time
then a complete charge requires at least 15 hours.
Disconnect the charged electric shaver from the power source. The red LED charging indicator A8
will turn off. A fully charged electric shaver will run for approximately 45 minutes. The operating
time may vary depending on the type of facial hair, etc.
Attention:
Do not leave the electric shaver connected to a charging source for longer than 24 hours. If you
regularly charge the electric shaver for longer than 10 hours then this will negatively impact the
battery capacity.
Do not use an electric shaver that is charging. Wait until it is charged.
USING THE ELECTRIC SHAVER
1. Remove the shaving foil protective cover A1.
2. To turn on the electric shaver, press the safety lock A7 while at the same time sliding the switch
A6 upwards to the ON position.
3. Place the foil A2 of the electric shaver on to your skin and make circular and direct motions against
the direction of beard growth. Hold it perpendicular to the skin that you are shaving while using
your other hand to keep the skin taut. Do not moisten the skin before or while shaving, and do not
use a shaving cream or gel.
6


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Sencor SMS 3014 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Sencor SMS 3014 in the language / languages: English as an attachment in your email.

The manual is 1,31 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info