759228
8
Zoom out
Zoom in
Previous page
1/10
Next page
EN-8
EN
Humidifier
SHF 910BL / SHF 911GR
02/2015
2015,
Clean the outer surface of the humidifier as required using a fine clean cloth lightly dampened in
lukewarm water.
For cleaning, do not use abrasive cleaning products and solvents as this could damage the surface
of the appliance.
Attention:
Do not leave water in the water tank A2 or in the water holder A9 for longer than a week.
Do not submerge the base unit Aqa in water or rinse it under running water.
TROUBLESHOOTING
Problem Possible cause Solution
The indicator light
A5 is not lit and
the humidifier
is not producing
steam despite the
required steam out
being set.
The humidifier is connected to
a faulty power socket or is not
connected to a power socket
at all.
Connect the humidifier to a working power
socket.
There is not enough water in
the water holder A9 or there
is no water at all.
Turn off the humidifier unit and disconnect it
from the power socket. Fill up the water tank A2
with cold clean water. Assemble the humidifier,
connect it to a power socket and start it again.
An odour can
be sensed in the
steam.
The odour may be sensed
when the humidifier is used
for the first time.
Open the water tank plug A3 and allow the
water tank A2 to ventilate for at least 12 hours.
Inside the water tank A2 /
water holder A9 there is dirty
water or you have left water
in the water tank A2 / water
holder A9 for too long.
Turn off the humidifier and disconnect it from the
power socket. Remove the water from the water
tank A2 and from the water holder A9. Clean
everything. Fill up the water tank A2 with cold
clean water. Connect the humidifier to a power
socket and start it again.
The humidifier
is producing
an insufficient
amount of steam
or is not producing
any steam at all.
There is not enough water in
the water holder A9 or there
is no water at all.
Turn off the humidifier and disconnect it from the
power socket. Fill up the water tank A2 with cold
clean water. Connect the humidifier to a power
socket and start it again.
The control dial A6 is set to
the off position or a low steam
output intensity is set.
Turn the control dial A6 clockwise to turn on the
humidifier. To increase the steam output intensity,
keep turning the control dial A6 clockwise.
The nebulizer A0 is clogged
with mineral deposits.
Turn off the humidifier and disconnect it from
the power socket. Clean out the nebulizer A0
according to the instructions in chapter Cleaning
and maintenance.
Inside the water tank A2 /
water holder A9 there is dirty
water or you have left water
in the water tank A2 / water
holder A9 for too long.
Turn off the humidifier and disconnect it from the
power socket. Remove the water from the water
tank A2 and from the water holder A9. Clean
everything. Fill up the water tank A2 with cold
clean water. Connect the humidifier to a power
socket and start it again.
The water tank A2 is not
correctly seated in the base
unit Aqa.
Place the water tank A2 on to the base unit Aqa
so that both parts fit together properly.
The nebulizer A0 or fan is not
working.
Contact an authorised service centre.
8


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Sencor SHF 910 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Sencor SHF 910 in the language / languages: English as an attachment in your email.

The manual is 0,89 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info