Manual Sencor SHF 2050 (page 5 of 6) (English)

759231

Zoom out

Zoom in

1/6

10/2016

- 5 -

EN Humidier

User'smanual

Prior to using this appliance, please read the user'smanual thoroughly, even in cases,

when one has already familiarised themselves with previous use of similar types of

appliances. Only use the appliance in the manner described in this user'smanual. Keep

this user'smanual in asafe place where it can be easily retrieved for future reference.

We recommend saving the original cardboard box, packaging material, purchase

receipt and responsibility statement of the vendor or warranty card for at least the

duration of the legal liability for unsatisfactory performance or quality. In the event of

transportation, we recommend that you pack the appliance in the original box from

the manufacturer.

HOW THE HUMIDIFIER WORKS AND ITS FEATURES

■ A humidier eectively increases indoor air humidity and thereby improves air

quality and has apositive eect on human health. It acts preventively against drying

out of the mucous membrane in the respiratory tract and prevents respiratory

illnesses. Its use is recommended primarily during the heating season, when, as

arule, indoor air is predominantly dry.

■ The SHF 2050BL / SHF 2051GR Humidier works on the principle of ahigh frequency

ultrasound oscillator. Thanks to this technology, it produces cold steam and does

not aect the temperature in the room. The humidifying performance is adjustable

and essential oils can be used to create a pleasant indoor atmosphere. With

a humidifying performance of 250 ml/h, it is suitable for rooms up to an area of

30 m2. Its large 4-litre water tank guarantees an operating time of up to 16 hours per

single rell. When there is an insucient amount of water in the tank, asignal is lit

and, at the same time, aprotective function is activated, which automatically shuts

o the humidier to prevent its damage. The automatic shut o is also activated,

when the water tank is removed during operation.

DESCRIPTION OF THE HUMIDIFIER

A1 Steam exhaust nozzle, 360° pivot

A2 Essential oil holder

A3 Steam outlet

A4 4-litre water tank

A5 Plug of the water tank lling

opening with awater release switch

A6 Water holder

Water is pumped into the water

holder from the water tank.

A7 Air exhaust opening

A8 Nebulizer

asurface where water is converted

into cold steam (mist).

A9 Base unit

A10 Light indicator of operation and low

water level in water holder

A11 Humidifying performance control

serves to turn o the appliance

and to set the output.

A12 Ventilation openings

OPERATING LOCATION OF THE HUMIDIFIER, ITS ASSEMBLY

AND FILLING THE WATER TANK

1. Always place the humidier on an even, dry and stable surface at a minimum

distance of:

– 60 cm from the oor;

– 30 cm from walls or sides of furniture;

– 200 cm from electrical and electronic devices or materials sensitive to moisture

to prevent their damage by the eects of increased humidity.

2. Make sure that the humidier is turned o and disconnected from the power socket.

Remove the nozzle A1 and lift the water tank A4 o the base unit A9. Turn it upside

down and turn anticlockwise to unscrew the plug of the lling opening A5 and

remove it.

3. Fill the water tank A4 with clean cold tap water. After lling up the water tank A4,

properly secure the plug A5 by turning it clockwise all the way. Turn the water tank

A4 upside down with the plug A5 facing downwards and place it back on to the

base unit A9 so that both parts t into each other properly. When the water tank A4

is placed on the base unit A9, water will start to be pumped into the water holder A6.

Attention:

The water tank A4 is lled with water up to 40 °C.

If you need to move the humidier, be especially careful not to spill the

water contained in the water holder A6.

4. After opening it, you may add afew drops of essential oil into the essential oil holder

A2 as shown in gure B1. Before using any essential oils, please ask the vendor or

an expert about its eects and correct dosage. Do not add anything other than

essential oils to the essential oil holder A2. After adding essential oil, close the

essential oil holder A2, see gure B2.

5. Place the nozzle A1 into the steam outlet A3.

USING THE HUMIDIFIER

1. Check that the humidier is correctly assembled. Connect the power cord to

apower socket. Turn the control dial A11 clockwise to turn on the humidier. The

indicator A10 will be lit green. The humidier will start producing cold steam within

a few moments. Ensure that during operation that the steam is not directed at

furniture or items sensitive to moisture. The steam exhaust direction can be set by

turning the nozzle A1 to the required angle.

2. Use the control dial A11 to increase or decrease steam output intensity during

operation. Turn the control dial A11 clockwise to increase steam output, turn it in

the opposite direction to reduce steam output. If you ll the water tank A4 up to the

edge, the expected operating time is up to 16 hours with the steam output set to

maximum intensity.

Attention:

If the humidier was transported at a temperature below the freezing

point, rst put it into room temperature and wait approx. 30 minutes before

turning it on.

Use the humidier at an ambient temperature of 5 to 40 °C and at arelative

humidity of up to 60 %. In the event that the ambient temperature falls

below 0 °C, turn the humidier o and remove the water inside the water

tank A4 and the water holder A6, to prevent it from being damaged.

Do not lift the water tank A4 out of the base unit A9 or touch the nebulizer

A8 while the humidier is running. For the event that the water tank A4 is

removed during operation, the humidier is equipped with a protective

automatic shut o function.

3. If the water level in the water holder A6 runs low, the indicator A10 will be lit red and

the humidier will automatically stop producing steam. This is asafety function to

prevent the nebulizer A8 from being damaged.

If necessary, ll up the water according to the instructions in point 2 and 3 in chapter

Operating location of the humidier, its assembly and lling the water tank. Then

you can start the humidier again.

4. To turn o the humidier, turn the control dial A11 anticlockwise all the way. The

indicator A10 will turn o. Disconnect the humidier from the power socket and

clean it out according to the instructions contained in the chapter Cleaning and

maintenance.

CLEANING AND MAINTENANCE

■ Before cleaning the humidier, turn it o and disconnect it from the power socket.

■ Please adhere to the following instructions relating to the cleaning and maintenance

of the humidier. Otherwise its performance may be negatively aected and

undesirable microorganisms may multiply inside the humidier.

Clean after every use

■ Remove the nozzle A1 from the steam outlet A3. Then take out the essential oil

holder A2 and clean out any remaining essential oil, and then put it back in its place.

Take the water tank A4 o the base unit A9, carry it to akitchen sink, turn it upside

down and open the lock A5. Remove any remaining water from it via the lling

opening, rinse it out with clean water and dry the surface using ane wiping cloth.

Finally, attach the lock A5 to the water tank A4, and insert the nozzle A1 into the

outlet A3.

■ Remove the water from the water holder A6 and wipe it dry using ane clean cloth.

Thorough cleaning (once per week)

■ Pour approximately 100 ml of vinegar into the water holder A6 and allow it to act for

15 minutes. Using abrush with gentle bristles, remove the limescale deposits in the

water holder A6 and the nebulizer A8. Then clean out all the remaining limescale

and vinegar using acloth dampened in clean water and wipe dry.

■ Thoroughly clean out the essential oil holder A2 under running water or using

adampened cloth and then put it back in its place.

Attention:

Do not leave water in the water tank A4 or in the water holder A6 for longer

than aweek.

Do not touch the nebulizer A8 with sharp objects in order not to damage it.

■ Clean the outer surface of the humidier as required using ane clean cloth lightly

dampened in lukewarm water.

■ Do not submerge the base unit A9 in water or rinse it under running water. For

cleaning, do not use abrasive cleaning products, solvents, etc. Otherwise, this could

damage the surface of the appliance.

TROUBLESHOOTING

Problem Possible cause Solution

The indicator light

A10 is not lit and

the humidier is not

producing steam.

The humidier is

connected to afaulty

power socket or is not

connected to apower

socket at all.

Connect the humidier to

aworking power socket and use

the control dial A11 to set the

required steam output intensity.

The indicator light

A10 is lit red.

There is not enough

water in the water

holder A6.

Turn o the humidier and

disconnect it from the power

socket. Fill up the water tank A4

with cold clean water. Assemble the

humidier, connect it to apower

socket and start it again.

An odour can be

sensed in the steam.

The odour may be

sensed when the

humidier is used for

the rst time.

Open the water tank plug A5 and

allow the water tank A4 to ventilate

for at least 12 hours.

There is dirty water in

the water tank A4 /

water holder A6.

Turn o the humidier and

disconnect it from the power

socket. Remove the water from

the water tank A4 and the water

holder A6. Clean everything. Fill up

the water tank A4 with cold clean

water. Connect the humidier to

apower socket and start it again.

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Sencor SHF 2050 in the language / languages: English as an attachment in your email.

The manual is 0,5 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Sencor SHF 2050

Sencor SHF 2050 User Manual - Dutch - 6 pages

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Sencor SHF 2050 Manual

Product: