757415
21
Zoom out
Zoom in
Previous page
1/22
Next page
At trouble Possible causes Solutions
Reference
Misalignment
of the time
and hand
positions
The watch displays an
incorrect time hour unit,
even though it displays the
precise time of minutes
and seconds.
The time zone selection is incorrect. Check the selected time zone and set it
to the area where the watch is used. P.30
Misalignment
of the date
The reception results are
successful and the precise
time is displayed, but the
date is not correctly
displayed.
The date is out of the preliminary
position.
This happens when the date is out of
the preliminary position as a result of
influence of various external sources or
after the built-in IC is reset.
Set the date to the preliminary position
“1” (the 1st). P.67
Operation The crown or button
cannot be operated.
The stored electric power is running
short.
Sufficiently charge the watch until it
starts moving at one-second intervals. P.36
Hands and date are moving right after
a setting is carried out by the crown or
button operation.
Wait without doing anything.
After the date stops, the crown and
button can be operated.
-
EN 76
7
TROUBLESHOOTING
At trouble Possible causes Solutions
Reference
Operation You get lost in the middle
of the operation. -----------
Return to the status before the start of
the operation, and try the operation
again.
If the crown is pulled out, push it in.
If the crown is not pulled out, then pull it
out and push it in again.
This will return to one-second interval
movement for a maximum of 9 minutes.
After this, try the operation again.
-
Others Blur on the dial glass
persists.
A small amount of water has got inside
the watch due to deterioration of the
gasket, etc.
Contact the retailer from whom the
watch was purchased. -
* For the solution of troubles other than the above, consult the retailer from whom the watch was purchased.
EN 77
7
TROUBLESHOOTING
In case of an abnormal movement
In the case that the watch moves abnormally or that the watch does not move at one-second intervals even
after fully charging the battery, then it can be returned to normal operation using the following operation.
Reset the system
012
Pull out the
crown to the
second click
1Pull the crown to the second click.
The seconds hand stops on the spot.
* When the crown is a screw lock type, unlock it.
→ P.13
EN 78
7
TROUBLESHOOTING
Press and hold the
button for 5 seconds
and then release it
3When all the hands stop pointing to 12 o’clock 0 minutes and 0 seconds, push
the crown back.
The seconds hand starts moving from 12 o’clock 0 minutes and 0 seconds.
* After a system reset, the time zone is set to JJY.
After completion of a system reset, perform the following operations.
“Set the preliminary position for the date, and the hour and minute hands.” → P.67
“How to select the time zone (How to display the local time around the world)” → P.30
“How to conduct manual reception (Receive a radio signal manually)” → P.58
* When the crown is a screw lock type, lock it. → P.13
2Press and hold the button for 5 seconds
and then release it.
After releasing the button, approximately 5 seconds
later the seconds hand moves, and stops at the
0-second position.
Then the hour and minute hands will start to move
and stop pointing to 12 o’clock 0 minutes.
* The button cannot be operated until all the hands stop.
EN 79
7
TROUBLESHOOTING
21


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Seiko 7B75 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Seiko 7B75 in the language / languages: English as an attachment in your email.

The manual is 5,23 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info