489299
7
Zoom out
Zoom in
Previous page
1/8
Next page
7
32
6
9
8
8
6
27
33
9
8
Wechsel der Filtertüte
Zum Wechseln der Filtertüte (28) den Fil-
terdeckel (6) auf der Oberseite mit Hilfe
des Verschlusshebels(29) entriegeln und
aufschwenken. Die Filtertüte mit dem
Filtertütendeckel (30) schließen und aus
dem Filterraum herausheben. Legen Sie
die neue Filtertüte in den Filterraum ein.
Bitte achten Sie hierbei auf die Position-
ierungspfeile auf der Filtertüte. Diese
zeigen die korrekte Positionierung der
Filtertüte an. Die grüne Lasche an der
linken Seite muss über dem Metallhebel
liegen. Beim Schließen des Filterdeckels
wird der Metallhebel zur Seite gedrückt.
Der Verschlusshebel des Filterdeckels
muss spürbar einrasten. Bei nicht korrekt
eingelegter Filtertüte lässt sich der Filter-
deckel nicht schließen.
Motorschutzfilter /
Elektret-Abluftfilter
Der Motorschutzfilter (31) ist nur zu-
gänglich nach Entnahme der Filtertüte.
Ziehen Sie nun den Filter an seinem Bügel
nach oben heraus. Beim Einsetzen eines
neuen Motorschutzfilters muss dieser fest
angedrückt werden. Der Motorschutzfilter
muss gewechselt werden, wenn er stark
verschmutzt ist oder spätestens nach 20
Filtertüten. Gleichzeitig sollte auch der
außen liegende Abluftfilter (11) ge-
wechselt werden. Hierzu müssen die bei-
den Filterbefestigungsringe (12) vorsichtig
gelöst und seitlich entfernt werden. Dann
die beiden Kunststoffschienen aus der Nut
im Filtergehäuse (5) herausziehen und
den Abluftfilter entfernen. Die Montage
erfolgt in umgekehrter Reihenfolge.
Nur wenn der Abluftfilter richtig montiert
ist, d.h. die Kunststoffschienen richtig in
der Nut liegen und die Filterbefesti-
gungsringe den Filter abdichten und
verschlossen sind, kann der Abluftfilter
seine Wirkung entfalten.
Entnahme der Rundbürste*
Um die Rundbürste der Elektroteppich-
bürste* zu entnehmen, die Press-Taste
(23) drücken und gleichzeitig das Loslager
(24) nach unten wegdrehen. Die Bürste
(25) etwas im Uhrzeigersinn drehen und
herausziehen. Es empfiehlt sich, regel-
ßig die auf der Rundbürste aufge-
wickelten Fäden und Haare zu entfernen.
Verstopfungen beseitigen
Erscheint das orangefarbene Signal (27)
am Filterdeckel (6) bei neuwertiger Fil-
tertüte, kann eine Verstopfung vorliegen.
Zuerst den Schlauch (8) an der Schlauch-
se überprüfen. Wenn dort nur eine
geringe Saugwirkung spürbar ist,
ist er
verstopft.
Danach den Schlauch durch Drehen des
Sicherungsrings (32) an der Innenseite
des Deckels lösen.
Stecken Sie dann die Schlauchdüse (9) in
den Schlauchstutzen des Filterdeckels (6)
und saugen sie von der anderen Seite aus.
Dazu den Schlauch an der Verstopfung
dehnen und mit der flachen Hand auf die
Öffnung des Schlauches klopfen. Über-
prüfen Sie auch den Saugkanal an der
Einsteckstelle (33) für die Schlauchse (9)!
* Je nach Modell.
Changing the Filter Bag
To remove the filter bag (28), open the
latch on the side of the bag housing (29).
Close the filter bag with the sealing cap
(30) and lift it out. Insert the new filter bag
into the bag housing. Please ensure that
the green bag top is in correct position.
The green flap on the left side of the filter
bag top should fit over the metal spring so
that it covers it. When the filter bag cover
is closed with the filter bag correctly in
place, the metal spring will move over to
allow it to shut and click into place. You
cannot close the filter bag cover if the
filter bag is fitted incorrectly.
Motor Protection Filter /
Exhaust Filter
The motor protection filter (31) is only
accessible by removing the filter bag. Lift
the motor protection filter up by the
bracket. When replacing the motor
protection filter make sure that it is
pressed in position tightly. The motor
protection filter should be changed when
it is dirty or at the latest when you have
used 20 filter bags.
Change the exhaust filter (11) at the same
time as the motor protection filter. To do
this, carefully remove the filter retaining
rings (12) and put them to the side. Next
pull the enforcement strips of the exhaust
filter out of the housing slot (5) and
remove the exhaust filter from the
housing.
When reassembling, please ensure the
exhaust filter is fitted correctly in the
housing slots and the filter retaining rings
are installed correctly. Otherwise the filter
will be ineffective.
Removing the Brush Roller *
The remove the brush roller, press the
button marked "PRESS" (23) and turn the
bearing (24) downward. Turn the brush
(25) slightly to the right and pull it out. We
recommend to regularly remove threads
and hair, which have been wound around
the brush roller.
Removing Blockages
If the orange bag full indicator (27) is
showing after the filter bag has been
changed and the filters are in good
condition, there is likely a blockage in the
system. First, check for suction at the end
of the hose (8). If you can only feel a small
amount of suction, the blockage is in the
hose. To unblock, loosen the safety ring
(32) on the lid.
Remove the hose from the machine and
reverse the airflow through the hose by
putting the hose handle (9) in the
connec-ting tube of the filter cover (6).
Stretch the hose in the spot where the
blockage is and open and close the end of
the hose.
Also check the suction opening, which the
hose handle (9) fits into.
* Depending on model.
30
28
6
29
24
23
25
11
11
5
12
12
11
28
31
7


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Sebo Felix at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Sebo Felix in the language / languages: English, German as an attachment in your email.

The manual is 4,36 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info