671283
10
Zoom out
Zoom in
Previous page
1/12
Next page
Mikrofilter und Abluftfilter wechseln.
Der SEBO AUTOMATIC XP hat zwei zu-
sätzliche Filter, den Mikro-Hygienefilter
und den Abluftfilter. Beide sind auch
zusammen mit zehn Filtertüten in der
SEBO Service-Box erhältlich. Der Mikro-
Hygienefilter (30) ist im Filtergehäuse
untergebracht. Der Filterdeckel (7) kann
nur geschlossen werden, wenn der Mi-
kro-Hygienefilter richtig eingesetzt ist.
Zum Einschieben den Sicherungsbügel
(31) anheben. Der Mikro-Hygienefilter
muss gewechselt werden, wenn er stark
verschmutzt ist oder spätestens nach
zwanzig Filtertüten. Gleichzeitig soll-
te auch der Abluftfilter (32) gewechselt
werden. Dieser befindet sich auf dem
Gerätefuß (9) unter dem Filtergitter (34).
Zum Wechseln den Verriegelungsknopf
(33) nach hinten drücken.
Die Filter nicht waschen.
Entnahme der Rundbürste XP1
Um die Rundbürste (35) zu entnehmen,
die Taste (36) drücken, das Loslager (37)
entfernen, die Bürste etwas im Uhrzei-
gersinn drehen und herausziehen.
Zum Einsetzen die Rundbürste einschie-
ben, drehen bis sie einrastet, die Taste
(36) drücken und das Loslager (37) auf-
setzen, bis es einrastet.
Es empfiehlt sich, die Rundbürste re-
gelmäßig von aufgewickelten Fäden und
Haaren zu befreien und von den Seiten
auszusaugen.
Entnahme der Rundbürste XP2/XP3
Die Rundbürste im Gerätefuß ist zwei-
teilig (35, 35a). Mit den Tasten (36, 36a)
lösen Sie das Loslager (37) und die Ab-
deckplatte (37a). Die große Bürste (35)
im Uhrzeigersinn drehen und heraus-
ziehen, die kleine (35a) entgegengesetzt
drehen und entnehmen. Zum Einsetzen
die Bürste einschieben und drehen bis
Sie einrastet. Die jeweilige Taste drücken
und das Loslager und die Abdeckplatte
aufsetzen bis sie einrasten. Niemals das
Gerät mit nur einer Bürste oder ohne
die seitlichen Abdeckungen (37, 37a)
einschalten. Die beiden Bürsten immer
zusammen austauschen. Es empfiehlt
sich, die Rundbürsten regelmäßig von
aufgewickelten Fäden und Haaren zu be-
freien und von den Seiten auszusaugen.
Wechsel der Dichtlippe
Die Taste (36) drücken, das Loslager (37)
entfernen und die Dichtlippe aus der Nut
herausziehen. Neue Dichtlippe einschie-
ben und Loslager wieder einsetzen.
35
37
36
36a
37a
35a
Changing the filters:
The SEBO AUTOMATIC XP has two ad-
ditional filters, the microfilter and the
exhaust filter. They are also available to-
gether with ten paper bags in the SEBO
Service-Box. The microfilter is located
in the dust bag compartment. The front
cover (7) can only be closed when the fil-
ter is fitted properly. Lift the metal bar
(31) to slide the filter in.
The exhaust filter is fitted on the base
(9) below a grill (34, filter cover). To re-
move the grill, push back the catch (33).
The microfilter (30) needs to be changed
when it is dirty, or before using twenty
paper bags. We recommend changing
the exhaust filter (32) with the microfil-
ter.
The filters must not be washed.
Removing the brush roller XP1:
To remove the brush roller (35) push the
button (36), remove the side plate (37),
turn the brush clockwise and pull the
brush roller out.
To replace, slide the roller into the brush
housing and turn it until it locates into
position. Push the button (36) and press
the side plate (37) back into place.
We recommend vacuuming out the brush
roller ends periodically to prevent a build
up of dust or fibre. When cleaning hair,
etc., from the brush roller, do not cut into
the bristles.
Removing the brush roller XP2/XP3:
The brush roller consists of two parts
(35, 35a).The push buttons (36, 36a) re-
lease the two side plates (37, 37a). Turn
the brushes (35 clockwise, 35a anti-
clockwise) and pull them out.
To replace, slide the two brush roller
parts into the brush housing and turn
them until they locate into position. Push
the respective button (36,36a) and press
the side plates back into place.
We recommend vacuuming out the brush
roller ends periodically to prevent a build
up of dust or fibre. When cleaning hair,
etc., from the brush roller, do not cut into
the bristles.
Replacing the hard floor strip:
Remove the side plate (37) and slide out
the strip. Slide new strip into the groove
and refit side plate.
35
36
37
30
31
33
34
32
20
7
10
10


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Sebo AUTOMATIC XP1 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Sebo AUTOMATIC XP1 in the language / languages: English, German as an attachment in your email.

The manual is 4,67 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info