776930
1
Zoom out
Zoom in
Previous page
1/2
Next page
Step 2: Clean and lube the O-rings regularly. Note: The
light uses two O-rings to maintain a waterproof seal.
1) O-rings and sealing surfaces must be clean.
2) Inspect O-rings for cuts, tears or other damage.
Replace if damaged or annually (item SL65303).
3) Lube O-rings lightly before each use with silicone
lube provided.
Step 1: Unscrew light head from grip and install one 18650-type rechargeable Li-ion battery or two single-use CR123
batteries. Batteries sold seperately. Recommend XTAR brand 18650 battery 2600 or 3400mAh for best performance.
Step 3: Long press the power button to power light on & off.
Note: Quick press power button to change 3 different light
modes: 100% power → 50% power →25% → repeat cycle.
Important:
1) After each dive, soak the sealed light in fresh water for
about 20 minutes to remove any residual salt, sand and
dirt. Dry light with clean towel before opening battery
compartment or storage.
2) A battery indicator light is located around power button.
Green = full power, yellow = half power and red = low
power (Replace/recharge battery).
3) Do not use rechargeable CR123 batteries.
4) Minimum requirements for 18650 battery: Button cell
top; Integrated protected circuitry; Minimum 2600 mAh;
Minimum 3.5A discharge current; Cell made in Japan by
reputable brand like Panasonic/Sanyo or Samsung.
5) Observe all SCUBA dive safety rules and control your
buoyancy at all times. Because fluoro diving takes place at
night, your ability to see your surroundings will be greatly
diminished when using a blue light in combination with
the mask filter. It is critically important that good
buoyancy practices are used and situational awareness is
observed at all times. Consult your dive instructor for dive
safety questions.
Guarantee: SeaLife warrants the original purchaser of this product, for a period of one (1) year from the date of purchase, that the
product is free from defects in workmanship and materials. In the event the original purchaser believes there is a defect in a product, it
is recommended that the purchaser first visit www.sealife-cameras.com for product updates, troubleshooting and repair service
information.
Sea Dragon Mini Fluoro Underwater Light (Item SL655) Instruction Sheet
Optional mounting adapters
The Mini Fluoro light may be mounted to any YS
mounting system, Flex-Connect mounting system or to
any UW housing cold shoe using the following
adapters:
A) YS Adapter for Sea Dragon Mini Fluoro (Item #
SL98104). Mount light to any YS arm or adapter.
B) Flex-Connect YS adapter (SL994). Mount light to
Flex-Connect arm, grip or adapter when combined
with YS adapter “A”.
C) Flex-Connect Cold Shoe (SL991). Mount light to
UW housing cold shoe when combined with YS
adapter “A” and Flex-Connect YS adapter “B”.
B
C
SeaLife (Div. of Pioneer Research), 97 Foster Road, Moorestown, NJ 08057 USA www.sealife-cameras.com
September 2017
1


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for SeaLife Sea Dragon Mini Fluoro - SL655 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of SeaLife Sea Dragon Mini Fluoro - SL655 in the language / languages: English, German, Dutch, French, Italian, Spanish as an attachment in your email.

The manual is 0.42 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info