776910
1
Zoom out
Zoom in
Previous page
1/2
Next page
Sea Dragon 4500
Pro Photo/ Video Light
(Item SL675)
4500
QUICK Guide
Carry
Case
1” ball joint
adapter with
w/ hex key
SEALIFE
97 FOSTER ROAD, MOORESTOWN, NJ 08057 USA
INFO@SEALIFE-CAMERAS.COM WWW.SEALIFE-CAMERAS.COM
START
Charge the battery.
Status light on AC power
adapter turns from red
to green when battery
is fully charged. Note:
Battery is preinstalled in
the light. Remove yellow
contact cover, which
prevents accidental
power on during
transportation.
What’s in the box:
Sea Dragon
4500 light head
with YS adapter
attached
1
1
Sea Dragon
Overview: The Sea Dragon Pro Photo/Video light delivers 4500 true lumens in a smooth, even 120° wide beam
without hotspots. Unmatched 96 CRI (color rendering index) and 97 TLCI (Television Lighting Consistency
Index) COB LED array that mimics natural sunlight. Brightness is adjusted manually in 4 steps (100% 75%,
50% and 25%) or automatically (from 10% to 100%) with its built-in photocell light sensor. The flash-detect
feature turns off the light for 1 sec. when nearby flash is fired. The light easily mounts to YS, 1” ball joint or
Flex-Connect system of arms, grips, trays and mounts. The 50Wh battery delivers 1hr run time at full power
and 4hrs at 25% brightness.
Flex-Connect
YS adapter
2
2Check if O-rings are lubed. O-ring
should appear shiny. If not, apply
small amount of silicon lube to
outside surface of O-rings. Wipe off
excess lube.
50W Li-ion battery
with protective cover,
charging tray and AC
power adapter
Int’l plug adapters
for EU, UK and AU
Spare O-rings w/ lube
and emoval tool
3
3Insert battery in light and screw
on waterproof battery cap until
fully seated. 4
4Connect light head to arm or grip (Sold seperately).
Use Flex-Connect YS adapter if connecting light to Flex-
Connect system of arms, grips and trays. Light may also be
mounted directly to YS arms and grips. Replace YS adapter
with included ball joint adapter if mounting to ball joint
arms and grips.
Push and hold power
button for 1 second to
power light on and off.
5
5
Push and release the power button to cycle
through 5 different brightness modes: 100%
75% 50% 25% Auto [repeat].
6
6Battery status indicator will be green when battery is 30% to 100% charged,
yellow when battery is 15% to 29% charged and red when battery is near empty.
There is a 10-minute 70-lumen safety reserve before light powers off when battery
is empty and - status indicator will blink red.
7
7
To activate emergency signal mode, push and hold power
button for 4 seconds from power off state. Push and
release power button to select between 1 sec blink interval
and SOS Morse code.
The Auto Flash Detect (AFD) feature is already activated. The light
will power off for 1 sec. when nearby flash is fired. To deactivate
AFD, push and hold power button for 5 seconds from power off state.
Push and release power button to select between AFD off (1 blink
per sec.) and AFD on (2 blinks). Push and hold the power button for 2
seconds to save the setting and power off the light.
9
9
8
8
IMPORTANT:
1. Avoid using the light above water for more than a few minutes. The front of the light head becomes very hot within a few minutes, which
may cause burning if touched. Water is needed to keep the light cool. A thermal sensor will dim the light if it overheats.
2. After use, soak sealed light in fresh water for 20 minutes to dissolve salt residue. Towel dry. Allow light to fully dry before storage.
3. If water has entered the battery compartment or under the lens port, immediately power off the light. On land, remove the battery.
Allow battery compartment to fully dry. Contact your local SeaLife dealer or SeaLife service center in your country for repair service.
4. Do not use battery that has become wet or if outer casing is cracked or damaged. Dispose of wet or damaged battery in accordance with
your local battery recycling regulations.
5. Remove battery from light before transporting, traveling or long term storage. Always use the included protective battery cover when
battery is not inside the light or charging tray to prevent accidental short-circuiting the battery contacts.
6. Do not obstruct the safety pressure release valve located under the light head.
7. Observe all SCUBA dive safety rules and control your buoyancy at all times. Consult your dive instructor for dive safety questions.
8. Visit SeaLife-Cameras.com for troubleshooting advice, updates to these instructions, spare parts and other helpful information.
GUARANTEE: SeaLife warrants the original
purchaser of this product, for a period of one
(1) year from the date of purchase, that the
product is free from defects in workmanship
and materials. In the event the original
purchaser believes there is a defect in a product,
it is recommended that the purchaser first visit
www.sealife-cameras.com for product updates
and information on how to get warranty repair
service. Please contact your local SeaLife dealer
or the importer in the country where the product
was purchased for return information.
APRIL 2018
1


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for SeaLife Sea Dragon 4500 - SL 675 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of SeaLife Sea Dragon 4500 - SL 675 in the language / languages: English, German, Dutch, French, Italian, Spanish as an attachment in your email.

The manual is 0.26 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info