644541
5
Zoom out
Zoom in
Previous page
1/80
Next page
5
MANUFACTURER:
scheppach
Fabrikation von Holzbearbeitungsmaschinen GmbH
Günzburger Straße 69
D-89335 Ichenhausen
DEAR CUSTOMER,
We wish you lots of fun and success in working with your
new scheppach machine.
NOTE:
As per the applicable Product Liability Law, the manu-
facturer of this device will not be liable for damages that
occur in this device or that are caused by this device in
the following cases:
Improper handling,
Non-observation of the operating instructions,
Repair by third parties, unauthorized technicians,
Installation and replacement with non-original spare
parts,
Use not in conformity with the manufacturer‘s speci-
cations,
Failures of the electrical system attributable to non-
observation of the electrical specications and VDE
clauses 0100, DIN 57113 / VDE0113.
WE RECOMMEND THE FOLLOWING:
Please read the instructions in the present manual care-
fully before using the tile-cutting machine.
Read the Instructions For Use:
Please read the Instructions for Use carefully before set-
ting up, commissioning or intervening in the machine.
Dangerous electric voltage
Caution! Switch off the mains power supply before mak-
ing any intervention in the tile-cutting machine.
Risk from sudden start
Caution! The tile-cutting machine can restart suddenly
after a power failure.
In addition to the safety clauses of this operating instruc-
tions manual, you must also observe the specications
of your country applicable to the operation of the ma-
chine without fail.
Keep the operating instructions manual in a plastic cover
near the machine, protected against dirt and humidity.
Pass the operating manual / safety instructions on when
you hand over to other people.
It must be read and observed carefully by all machine
operators before starting work on the machine.
Only persons who are trained to use the machine and
who have been instructed about the risks involved
should be allowed to operate the machine. The required
minimum age of workers must to be observed.
FABRICANT:
scheppach
Fabrikation von Holzbearbeitungsmaschinen GmbH
Günzburger Straße 69
D-89335 Ichenhausen
CHER CLIENT,
Nous vous souhaitons beaucoup de plaisir et de succès
lors de l’utilisation de votre nouvelle machine scheppach.
REMARQUE:
Conformément à la loi relative à la responsabilité du fait
des produits défectueux applicable, le fabricant n’est pas
responsable des dommages à cet équipement ou décou-
lant de celui-ci en cas de :
Maniement incorrect,
Non-respect des instructions d’utilisation,
Réparations effectuées par des tiers, par des spécia-
listes non autorisés,
Installation et remplacement des pièces de rechange
n’étant pas des pièces d’origine,
Utilisation non conforme,
Défaillances du matériel électrique en cas de non-res-
pect des règles électriques et des dispositions VDE
0100, DIN 57113 / VDE0113.
NOUS VOUS RECOMMANDONS:
De lire attentivement les instructions contenues dans le
présent manuel avant la mise en service du coupe car-
relage.
Lire le manuel d’utilisation:
Lisez attentivement le manuel d’utilisation avant d’instal-
ler la tronçonneuse à disque, de la mettre en service ou
d’y effectuer des interventions.
Tension électrique dangereuse
Attention! Coupez l’alimentation électrique avant d’effec-
tuer une intervention quelconque sur le coupe carrelage.
Risque de démarrage soudain
Attention! Le coupe carrelage peut redémarrer de ma-
nière soudaine après une panne de courant.
En plus des consignes de sécurité contenues dans le
présent manuel, il est impératif d’observer les prescrip-
tions nationales en vigueur se référant à l’utilisation de
la machine.
Conservez ce manuel dans une pochette en plastique
sur la machine, à l’abri de la saleté et de l’humidité.
oignez le mode d’emploi/les consignes de sécurité à la
machine si celle-ci est transmise à un tiers.
Ce manuel doit être lu et observé à la lettre par tout utili-
sateur avant la mise en service de la machine.
Seules des personnes sont autorisées à utiliser la ma-
chine, qui ont été formées à l’utilisation de la machine
et des dangers y associés. Respectez l’âge minimum
requis.
5


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Scheppach FS3600 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Scheppach FS3600 in the language / languages: English, German, Dutch, French as an attachment in your email.

The manual is 4,25 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info