639149

Scandomestic SD 46 Manual

2
Zoom out
Zoom in
Previous page
1/4
Next page
2
TRANSPORTATION AND INSTALLATION
1 Place on level oor and remove the bottom packing, in order
to decrease the shock and noise.
The angle between the compartment body and ground
should be no more than 45°
2 Enough space should be left between the freeze and the
wall for ventilation.
3 Place the freezer away from heat source and do not expose
to direct sunshine.
4 Do not install where there is moisture or where it can easily
be splashed by water.
5 Do not place the freezer in environment prone to freezing.
6 The appliance should not be used in open air and should not
be exposed to rain.
ADJUSTMENT AND RUNNING
1 Adjustment of temperature: The storing temperature can be
adjusted by the thermostat of the compartment. The ther-
mostat should be adjusted according to different environ-
ment temperature and the food by rotating the knob of the
thermostat. The knob rotates clockwise from ”1” to “7”(or
direction arc)and the inside temperature turns down in
summer (anti-clockwise rotation)and up in winter(clockwise
rotation). It is usually xed to a certain point before leaving
the factory. Do not adjust too often or touch the other parts.
2 Trial running: plug in and wait. The marked drop in tempe-
rature within half an hour indicates that the freezer works
properly.
The compressor should be left to run for a period of time(6
hours in summer 4 hours in winter )before putting the food
in.
SAFETY PRECAUTIONS
1 The freezer should use a single 3-pin socket with (13A)fuse.
A multi –plug outlet should not be used.
2 You should install a suitable automatic voltage regulator not
less than 500w when the voltage is outside the range from
187V to 242V.
3 The sockets of the freezer should be connected to stable
xed connection. Under no circumstance should the wiring
be connected to such facilities as water pipe, gas pipe and
so on.
4 Once power is cut off, wait for at least 5 minutes before
plugging in again to avoid damaging the compressor or the
system.
5 Do not put combustible ,explosive or volatile dangerous
articles, heavily corrosive acid or alkali of liquid in glassware
into the freezer.
6 Children should be kept away from the freezer to avoid da-
mage to the inner container or any accidents being incurred
7 If the power cable damages, for avoid dangerous, must by
manufactory or its maintain a set or similar profession job
the personnel replaces.
FREEZING METHODS
1 Do not put too much food into the freezer or exceed the
loading line.
2 proper space should be allowed between foods to ensure
cooling air circulation.
3 Never use corrosive detergent, hot water, or washing power
to clean the freezer.
4 Do not use water to scour the freezer. Do not use hard bru-
shes or wire brushes to clean the freezer.
5 Do not use metal or sharp tools for defrosting.
6 Do not use electric heaters to heat up and defrost.
7 The green lamp is a power indicating lamp. When the power
is on, the lamp will be on.
TROUBLE SHOOTING:
The design and production comply with the relative security
standard of China. If you nd it does not work as usual, please
examine and handle it according to the following table rst. If
the situation does not improve, you must contact our after-sale
service center or our special repair division to examine and repair
the appliance.
The following problems are not causes of breakdown:
There is a sound of liquid owing in the freezer It is the
sound of refrigerant owing in the circulating pipeline of the
refrigerating system.
- It is normal.
Too noisy
- The freezer is not installed in a level ground.
- Change the position.
The refrigerating system does not work for a It is an indicator
of high quality for its long time but the inside temperature is
very good insulation and low cooling retention low.
- It is normal.
2


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Scandomestic SD 46 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Scandomestic SD 46 in the language / languages: English as an attachment in your email.

The manual is 0,82 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info