699608
12
Zoom out
Zoom in
Previous page
1/15
Next page
10 SATEL CA-4v1
access code 3 not pre-programmed
access code 4 not pre-programmed
service code 12345
zones bypassed none
zones delayed 1
24 hour zones 4
exit delay time 5 seconds
entry delay time 10 seconds
alarm time at OUT1 5 seconds
alarm time at OUT2 10 seconds
Activating sequence: 9.#.. ...
Arm/Disarm status information
If arm/disarm status can be signaled with the OUT2
output, default setting may be changed using
function 8. Normally, the output signals an alarm
after the alarm time being programmed (from 001 to
998 seconds). If value 000 or 999 is entered, the
function of the output is to signal arm/disarm status.
Value 000 means that OUT2 will set the
voltage to 0V (relative to the COM terminal)
when the panel is armed.
Value 999 means that OUT2 will set the voltage to 12V when the panel is armed.
The bias resistor (for example 1k), that limits the input current from terminal +OUT2,
must be connected to the output.
Activating sequence: 8.#.. ...
Example: programming of the armed mode signaling (while in armed
mode the OUT2 will be set to 12V)
9.9.9.
Resetting the panel
If the user forgets the access codes, entering service mode is possible through the
following procedure:
1. disconnect the net and battery power supply sources,
2. short the JP1 RESET jumper pins (see figure 1),
3. connect the power supply,
4. after three short beeps in the keypad remove the JP1 jumper from the pins,
5. call function 9 to restore manufacturer settings and program the remaining
parameters (using service functions 2 through 8).
+OUT2
-OUT2
COM
OUT2
R
Figure.6 Example of connection
the bias resistor to OUT2
12


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Satel CA-4v1 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Satel CA-4v1 in the language / languages: English as an attachment in your email.

The manual is 0,17 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info