699623
9
Zoom out
Zoom in
Previous page
1/13
Next page
SATEL AOD-210 7
11. Fasten the electronics module in the enclosure.
12. If you have mounted the detector on a bracket, connect an additional tamper switch to the
TMP terminals (black wire to one terminal, blue wire to the other) and remove the jumper
from the pins.
13. Replace the cover.
14. Configure the detector settings (sensitivity of PIR sensor, sensitivity of microwave sensor,
sensitivity of dusk sensor [detection threshold], etc. – see the ABAX 2 / ABAX controller
manual / the INTEGRA 128-WRL control panel manual).
If the detector is to be pet immune, for the infrared and microwave sensors do not set
the detection sensitivity higher than default (PIR sensor sensitivity: 2, MW sensor
sensitivity: 1).
15. Start the test mode (see the ABAX 2 / ABAX controller manual / the INTEGRA 128-WRL
control panel manual).
16. Check whether moving around within the detector coverage area will get the LEDs to
come on. Fig. 9 shows the maximum detection range and the creep zone .
17. End the test mode.
4.1 Angle bracket mounting
1. Attach extra tamper switch:
screw the holder to the tamper switch (Fig. 7-I),
screw the tamper unit to the enclosure base (Fig. 7-III).
Figure 7 shows mounting the tamper switch in one of two available positions. The
place of tamper switch installing depends on the way of angle bracket mounting. If the
tamper switch is to be installed in the other position, place tamper switch holder on the
other side.
2. Prepare openings in the bracket for screws.
3. Using wall plugs and screws, fasten the bracket to the wall.
4. Run the tamper switch wires through the hole made in the enclosure base.
It is recommended that the tamper switch wires be placed in a heat shrink tubing. This
will reduce the risk of water penetration into the enclosure.
5. Using screws, fasten the enclosure base to the bracket (Fig. 7-IV).
9


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Satel AOD-210 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Satel AOD-210 in the language / languages: English as an attachment in your email.

The manual is 0,32 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Satel AOD-210

Satel AOD-210 User Manual - German - 13 pages

Satel AOD-210 User Manual - Dutch - 13 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info