699623
4
Zoom out
Zoom in
Previous page
1/13
Next page
2 AOD-210 SATEL
Radio communication
The detector connects to the controller / control panel at regular time intervals to provide
information about its state (periodical communication). Additional communication may take
place as a result of alarm (see “Operating modes”).
Alarms
The detector will report alarm:
after detecting a motion in the protected area by both sensors within a time period shorter
than 4 seconds (this alarm can only be reported in the active mode – see “Operating
modes”),
after detecting a fault in the motion detection system,
when the light intensity drops below a defined threshold,
after opening the tamper switch (tamper alarm).
Operating modes
Active – information about tamper alarm, motion detection alarm and light intensity drop
alarm is sent immediately. The microwave sensor is enabled after motion is detected by
the infrared sensor.
Passive – only information about tamper alarm and light intensity drop alarm is sent
immediately. The microwave sensor is disabled, therefore no alarm can be triggered after
motion is detected. During periodical communication, information on whether the PIR
sensor detects motion is sent. This operating mode prolongs the battery life.
The detector operating mode is turned on remotely. If the detector is used in the INTEGRA /
VERSA alarm system, the operating mode may depend on the partition state (partition
disarmed – passive mode; partition armed – active mode). For more information, refer to the
ABAX 2 / ABAX controller manual / the INTEGRA 128-WRL control panel manual.
Energy saving mode (ECO)
If you want to prolong the battery life, you can enable in the detector the “ECO” option. When
the “ECO” option is enabled, the periodical communication takes place every 3 minutes. Thus
the battery life can be increased as much as fourfold. The option is only available in the
ABAX 2 system. The detector with “ECO” option enabled meets requirements of the
EN50131-2-4 standard for Grade 2.
Dusk sensor
Figure 1 shows the way the dusk sensor operates. On the timeline the T time delay is
presented (in operating mode T=15 min, in configuring mode T=3 s). Illustrated with the letter
H light intensity hysteresis and time delay make the sensor immune to short and accidental
changes of light intensity. Table 1 presents light intensity values for four detection thresholds.
For description of how to configure the sensor, please refer to the ABAX 2 / ABAX controller
manual / the INTEGRA 128-WRL control panel manual.
Information about the light intensity drop below the defined threshold (alarm) and the light
intensity restoration above the threshold (alarm restore) is sent instantly (regardless of the
operating mode).
4


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Satel AOD-210 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Satel AOD-210 in the language / languages: English as an attachment in your email.

The manual is 0,32 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Satel AOD-210

Satel AOD-210 User Manual - German - 13 pages

Satel AOD-210 User Manual - Dutch - 13 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info