783735

Saro GTK1000 Manual

18
Zoom out
Zoom in
Previous page
1/20
Next page
4.7. Parameter lock
Press ▼ for more than 10 sec. the screen
flashes “OFF” to indicate the parameter has
been locked. The parameters and controlling
temperature could be only watched but not
calibrated in the lock status. The screen flashes
“ON” to indicate unlock the parameters
(default is “OFF).
5. Function instructions
5.1. Temperature controlling:
- Compressor starts up when the storage
temperature is higher than the
controlling temperature +
temperature reference, fan starts up in
3 sec. When temperature is lower than
the controlling temperature,
compressor stops working and the fan
stops simultaneously
- To protect compressor, the stop time
for compressor must be longer than the
delay time (refer to E4) then the
compressor could be start up again
5.2. Timing defrosting.
- The unit will stop to defrost
automatically after running a period
(refer to F2). The compressor stops to
work and fan starts up the unit will
enter the temperature controlling
status automatically when defrosting
ending (refer to F1).
- If F4=1, the screen displays the
temperature of the point at defrosting
start. After the defrosting finishes, the
storage temperature displays the delay
time set by F6, the screen returns to
display the normal temperature.
- The defrost function will be cancelled
when the defrosting cycle is 00.
- In normal working status and the value
of F2 is not 0, press “set” and
for more than 10 sec. to force
enter the defrost status. It will run for
the period set by F1 and exit to the
normal working status automatically.
4.7. Parameter Sperre
Drücken Sie ▼ für mehr als 10 Sekunden.
Der Bildschirm blinkt "OFF", um anzuzeigen,
dass die Parameter gesperrt wurden. Die
Parameter und die Kontrolltemperatur
konnten im Sperrstatus nur beobachtet,
aber nicht geändert werden. Der Bildschirm
blinkt "ON", um anzuzeigen, dass die
Parameter wieder entsperrt sind (Standard
ist "OFF").
5. Funktionsanweisungen
5.1. Temperaturregelung:
- Der Kompressor läuft an, wenn die
Temperatur im Kühlschrank höher als die
Regeltemperatur + Temperatur Differenz
ist, der Ventilator läuft in 3 Sekunden an.
Wenn die Temperatur niedriger als die
Regeltemperatur ist, stoppt der Kompressor
den Betrieb und der Ventilator stoppt
gleichzeitig.
- Um den Verdichter zu schützen, muss die
Stoppzeit des Verdichters länger als die
Verzögerungszeit (siehe E4) sein, damit der
Verdichter wieder in Betrieb genommen
werden kann.
5.2. Zeitpunkt des Auftauens.
- Das Gerät stoppt nach Ablauf einer
Periode automatisch zum Abtauen (siehe
F2). Der Kompressor stoppt und der Lüfter
startet, das Gerät geht nach Abtauende
automatisch in den Status der
Temperaturregelung über (siehe F1).
- Wenn F4=1, wird auf dem Bildschirm die
Temperatur des Abtaustartpunktes
angezeigt (siehe F1). Wenn Abtauen
beendet ist, zeigt die Speichertemperatur
die mit F6 eingestellte Verzögerungszeit an,
der Bildschirm kehrt zur Anzeige der
Normaltemperatur zurück.
- Die Abtaufunktion wird aufgehoben, wenn
der Abtauzyklus 00 ist.
- Im normalen Betriebszustand und wenn
der Wert von F2 nicht 0 ist, drücken Sie
"SET" und länger als 10 Sekunden,
um den Abtaustatus zu
erzwingen. Er läuft für die mit F1
… 18


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Saro GTK1000 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Saro GTK1000 in the language / languages: English, German as an attachment in your email.

The manual is 1.74 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info