2625
AFTER USE
2
Turn off the POWER.
1
Set the back rest and the foot
rest to the starting position.
Close the cover of remote
control.
Put the remote control
and the sensor controller
back on the stand.
Be sure to check that there are no children,
pets, or any obstacles around the massager.
MAINTENANCE PROCEDURE
HEAD COVER, BACK PAD, SEAT COVER, ARM REST (Artificial leather type)
Perform daily maintenance by wiping with a soft dry cloth. When they are badly soiled,
adopt the following maintenance procedure:
Do not force-dry with a drier.
Do not make contact with vinyl products
for an extended period. It may cause
discoloration.
Wipe with a soft dry cloth.
Soak a soft cloth in diluted neutral kitchen
detergent, and squeeze it well. Wipe the
main unit with the damp cloth, and wipe
it with a dry cloth afterwards.
MAIN UNIT (Cloth part, plastic parts, and pipe)
REMOTE CONTROL, SENSOR CONTROLLER
Do not wipe with a damp cloth.
Do not attempt to use benzene, thinner, alcohol, alkaline detergent or bleaching agent for cleaning,
as this may result in deformation, discoloration or cracking.
Do not wash the head cover and the back pad. This may cause discoloration or deformation.
NOTE
Coin
Lower
LOCK switch
POWER switch
Press
Be sure to disconnect the power plug from the outlet prior to maintenance.
WARNING
After use, be sure to set the POWER switch to the [OFF] position, and the LOCK switch to the
[LOCK] position.
When the equipment will not be used for an extended period, be sure to disconnect the power
plug from the outlet
CAUTION
Back rest
Hook-and-loop
fastener
Head cover
Back pad
Head cover
Back pad
Towel
WHEN THE MASSAGE IS FELT TO BE STRONG (WEAK)
Use the massager by putting a towel, etc.,
on the back pad.
When the massage is felt to be strong
When the massage is felt to be weak
Turn the back pad to the rear.
Take off the head cover from
the back pad.
When the foot rest is extended,
return the foot rest to the home
position by pulling the foot rest
slide lever.
When the display part
of the remote control
does not turn off, press
the OERATION ON/OFF
button.
Turn the back pad to the rear.
Bring all parts of the massage chair
to their home position by pressing
the HOME POSITION button.
Set the POWER switch
to the [OFF] position,
and the LOCK switch
to the [LOCK] position
by using a coin.
Attach the head cover to the
back rest.
Press
Soak a cloth in clean water, and
squeeze it well. Wipe off the remaining
detergent with the damp cloth.
Wipe it with a dry cloth afterwards.
Soak a soft cloth in diluted
neutral kitchen detergent,
and squeeze it well.
Wipe the main unit with
the damp cloth with
a tapping motion.
