1312
REMOVING AND CLEANING THE ACCESSORIES
Ice cube maker (optional)
• Hold the knob of ice cube maker, then pull the ice cube
maker forward.
• Remove the ice cube maker and rinse it in water.
Ice tray (optional)
• Using the handle, pull the ice tray out as far as it will go,
then remove it by lifting it up slightly and pulling it towards
you.
Fresh salad drawers
• Pull the salad drawers out as far as it will go, then
remove it by lifting it slightly and pulling it towards you.
• Wipe it with a damp cloth.
Bottle guard
• Hold the bottle guard in both hands, then remove it by
lifting it slightly and pulling it towards you.
• Wash it in water.
Freezer drawer
• Holding the freezer drawer in both hands, pull it out as far
as it will go, then remove it by lifting it up slightly and
pulling it towards you.
• Wipe it with a damp cloth.
INSTALLING A REGULAR BOTTLE
Press the fixing lever, lift the exclusive water tank
upwards, then remove it.
Remove the water supply device from the exclusive
water tank, then set the inner groove of the water
supply device in a regular mineral water bottle and
fix it in position by turning it.
Turn the water supply device over, then fix it in
position in the fixing hole.
• Gurgling sounds may be heard when air enters the water tank from regular mineral water or
beverage bottles.
• Some regular mineral water or beverage bottles may not fit the water supply device, depending
on their size.
• If water does not come out satisfactorily when you press the “push” button, press it again.
• Do not use carbonated drinks, such as cola, cider or sodas. When you press the button, the
beverage may spurt out due to the pressure of carbonic gas accumulated in the upper part of
beverage bottle.
• For better hygiene, beverages with a high sugar content (juice, soft drinks) are not
recommended.
• Use bottled mineral water or boiled tap water that does not contain any particles.
Transparent, safety glass shelf (optional)
• Remove the shelf, then clean it using water and
detergent.
• When replacing the shelves, do not mix up the top,
middle and bottom shelves.
Rubber seals
• Clean the rubber seals with a damp cloth and detergent.
Use a wooden skewer wrapped in a small cloth to clean
in the grooves.
Before cleaning the appliance, you must always switch it off and unplug it from the wall socket.
Do not use a steam cleaner. The hot steam could damage the surface of the appliance or the electrical
components, causing a risk of electric shock.
Note
When you remove the tempered glass shelves, load a glass and a trim simultaneously to
prevent from dropping the glass.
Note
