630070
4
Zoom out
Zoom in
Previous page
1/40
Next page
4
ENGLISH
Guided Tour - CR4 Receiver
1: Antenna A and B mountings - Connect the supplied antennas to these mountings. Third-party receiver
antennas should not be substituteduse only the antennas provided with the CR4. See the Setting Up and
Using the Concert IV System section on page 6 for more about antenna installation and positioning.
2: Volume - This knob determines the level of the audio signal sent from both the balanced and unbalanced
output jacks on the rear panel.
3: “A”/“B” LEDs - When signal is being received, one of these LEDs will be lit, showing you whether signal from
either the A or B antenna is currently being used. A computer chip inside the CR4 constantly scans the two
and automatically selects whichever is receiving the strongest, clearest signal. This Microprocessor True
Diversity switching is completely inaudible, and it effectively increases overall range while reducing potential
interference and phase cancellation problems.
4: AF Level meter - This ladder display (similar to the VU bar meter used on audio devices) indicates the
strength of the incoming audio signal. When the 100% segment is lit, the incoming signal is optimized at unity
gain; when the 125% segment is lit, the signal is overloading. When only the left-most 10%segment is lit, the
incoming signal is at just 10% of optimum strength. If no segments are lit, little or no signal is being received.
For more information, see the Setting Up and Using the Concert IV System section on page 6 in this manual.
5: Squelch control - This control determines the maximum range of the CR4 before audio signal dropout.
It should normally be left at its factory setting. For more information, see the Setting Up and Using the Concert IV
System section on page 6 in this manual.
6: Power switch - Use this to turn the main power on and off.
7: Rear-mount antenna knockouts - The CR4 antennas (normally mounted on the front panel) can optionally
be mounted on these areas of the rear panel. Contact Samson or your local distributor for further information.
8: DC input - Connect the supplied AC adapter here. WARNING: Do not substitute any other kind of power
adapter; doing so can cause severe damage to the unit and will void your warranty.
9: Balanced output* - Use this electronically balanced low impedance (600 Ohm) XLR plug when connecting the
CR4 to the microphone input of professional (-30 dBm) audio equipment, wired as follows: Pin 1 ground, Pin 2
high (hot), and Pin 3 low (cold).
10: Unbalanced output* - Use this unbalanced high impedance (5K Ohm) 1/4" jack when connecting the CR4 to
the microphone input of consumer (-10 dBv) audio equipment, wired as follows: tip hot, sleeve ground.
* If required, both the balanced and unbalanced outputs can be used simultaneously.
ANTENNA - B ANTENNA - A
UNBALANCED
OUTPUT
BALANCED
OUTPUT
1. GND
2. HIGH
3. LOW
-30 dBm 600
-10dB 5K
DC INPUT
12V=DC
2.4W (200mA)
PLUG LOCK
FOR AC
ADAPTOR
+
-
SAMSON
RECEIVER
MADE IN U. S. A.
FCC ID: CCRCR4
THIS DEVICE COMPLIES WITH PART 15 OF THE FCC RULES.
OPERATING IS SUBJECT TO THE FOLLOWING TWO CONDITIONS:
1. THIS DEVICE MUST NOT CAUSE HARMFUL INTERFERENCE AND
2. THIS DEVICE MUST ACCEPT ANY INTERFERENCE RECEIVED
INCLUDING INTERFERENCE THAT MAY CAUSE UNDESIRED OPERATION
CAUTION: USE 12VDC OUTPUT ADAPTER ONLY
ATTENTION: ANTENNA INPUT CONNECTORS ARE PHANTOM POWERED
BY DC 9V/25mA MAX. DO NOT SHORT
SAMSON
TECHNOLOGIES CORP., NEW YORK, U. S. A.
7
7
8 9 10
0
1
3
4
5
6
7
8
9
10
2
ANT.A VOLUMEANT.A ANT.B POWER ANT.B
ON
OFF
min
max
SQUELCH
CONCERT IV
AF LEVEL
10% 25% 75% 100% 125%
VHF TRUE DIVERSITY
WIRELESS SYSTEM
SAMSON
1
1
2
33 4 5 6
4


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Samson CT4G at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Samson CT4G in the language / languages: English, German, French, Spanish as an attachment in your email.

The manual is 0,37 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info