623979
12
Zoom out
Zoom in
Previous page
1/16
Next page
8
8
Setting Up and Using the
Concert Series System
12. Temporarily turn down the level of your mixer/amplifier system and turn off the power to
your transmitter, leaving the CR277 on. Then restore the previously set level of your mixer/ampli-
fier. With the transmitter off, the receiver output should be totally silent—if it is, skip ahead to the
next step. If it isn’t (that is, if you hear some noise), you may need to adjust the CR277 front panel
Squelch control. When the Squelch control is at its minimum setting, the Concert Series system
always provides maximum range without dropout; however, depending upon the particular
environment your system is used in, you may need to reduce that range somewhat in order to
eliminate band noise when the transmitter is turned off. To do so, use the provided screwdriver to
rotate the Squelch control completely counterclockwise (to the “Min” position), then slowly turn
it clockwise until the noise disappears. If no noise is present at any position, leave it at its fully
counterclockwise “Min position (so as to have the greatest overall range available).
13. When first setting up the Concert Series system in a new environment, it’s always a good idea
to do a walk-around in order to make sure that coverage is provided for your entire performance
area. Accordingly, turn down the level of your audio system and turn on both the transmitter and
receiver. Then, with the transmitter un-muted, restore the level of your audio system and while
speaking or singing, walk through the entire area that will need to be covered. Always try to
minimize the distance between transmitter and receiver as much as possible so that the strongest
possible signal is received from all planned transmission points. In fixed installations such as A/V
or corporate conference rooms or for extended range applications (where the transmitter and
receiver are more than 150 feet apart), it may be desirable to angle the antennas differently from
their vertical position or to install the receiver in the same room as the transmitters (and, if neces-
sary, to extend the wiring to remote audio equipment).
If you have followed all the steps above and are experiencing difficulties, contact your local dis-
tributor or, if purchased in the United States, call Samson Technical Support (1-800-372-6766)
between 9 AM and 5 PM EST.
12


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Samson Concert 277 Dual at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Samson Concert 277 Dual in the language / languages: English as an attachment in your email.

The manual is 1 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info