735233
2
Zoom out
Zoom in
Previous page
1/2
Next page
Produktkonformität & Sicherheitsinformationen
Produktkonformität
SALUS Controls erklärt hiermit, dass das Produkt den wesentlichen Anforderungen
der folgenden EG-Direktiven entspricht: 2014/30/EU, 2014/35/EU und 2011/65/
EU. Der vollständige Text der EU-Konformitätserklärung ist über die folgende
Internetadresse verfügbar: www.saluslegal.com.
Sicherheitsinformationen
Gemäß den Sicherheitsregulierungen verwenden. Das Gerät ist für die Steuerung
der Raumtemperatur in geschlossenen Räumen zu verwenden.
Installation
Dieses Zubehörteil muss durch eine kompetente Person eingebaut werden und
die Installation muss mit den Richtlinien und Normen konform gehen, die für die
Stadt, das Land oder den Staat, in dem das Produkt installiert wird, gelten. Ein
Versäumnis, diese relevanten Standards einzuhalten, könnte zu strafrechtlicher
Verfolgung führen.
Achtung: Alle elektrischen Installationsarbeiten sollten von
einem geeigneten, qualifizierten Elektriker oder einer sonstigen
kompetenten Person durchgeführt werden.
Produktbeschreibung
Danke, dass Sie den SALUS HTR230 Thermostat gekauft haben. Dieser
Thermostat ist ein Gerät, mit dem Sie die Heizung und Kühlung Ihres Heimes
nach Bedarf steuern können.
Der HTR230 ist eine elektronische Raumtemperatursteuerung, die gegenüber
konventionellen mechanischen Produkten eine Reihe von wesentlichen
Vorteilen bietet.
Die Steuerung lässt sich mit der konventionellen, von hinten beleuchteten
Wählscheibe leicht bedienen und bietet Ihnen den einzigartigen
Steuerkomfort für Heizanwendungen aller Art dank der qualitativ hochwertigen
Geräteelektronik.
Wir wünschen mit dem Produkt viel Freude.
Verpackungsinhalt
Inhalt der Bedienungsanleitung:
Verpackungsinhalt
Einleitung
Produktkonformität und
Sicherheitshinweise
Installation
Benutzerschnittstelle
Status/LED-Anzeige
Für den Monteur Garantie
Symbole, die in dieser Anlei-tung
verwendet werden:
Sicherheit
Wichtige Informationen
Ihr Vorteil
Fixing Screws
1 x Installer Manual
Dial Thermostat
Model: HTR230
INSTALLER MANUAL
SALUS Controls plc
SALUS House
Dodworth Business Park South,
Whinby Road,
Dodworth, Barnsley S75 3SP, UK.
Sales: T: +44 (0) 1226 323961
E: sales@salus-tech.com
Technical: T: +44 (0) 1226 323961
E: tech@salus-tech.com
www.salus-controls.com
SALUS Controls is a member of the Computime Group
Maintaining a policy of continuous product development SALUS Controls plc reserve the right to
change specification, design and materials of products listed in this brochure without prior notice.
Issue Date: Dec 2015
00086/2
For PDF Installation guide please
go to www.salus-manuals.com
8. Technical Specification
Model: HTR230
Voltage:
230 V AC, +-10%, 50/60 Hz
Operating Performance:
230 V: 1,8 W
Temperature setback:
Temperature range:
2°C-4°C
5°C- 30°C
Span:
+/- 0,5°C
Calibration:
Yes, with jumper
Storage temperature:
-20°C to +60°C
Ambient temperature:
0 °C up to 45 °C
Degree of protection:
IP 30
CE conformity according to:
Class II ( EN60730 )
Housing material:
PC, V2
Color:
RAL 9010 pure white
Connection:
Screw terminal
Weight
90g net / 135g gross
Puls-wide-modulation:
(PWM)
Yes
Valve protection:
Heating and Cooling:
Cooling blocked:
Dimensions:
Yes
Yes, automatically Change Over on the CO terminal
Yes, with jumper
85mm*85mm*25mm
Warranty
SALUS Controls warrants that this product (HTR230) will be free from any
defect in materials or workmanship, and shall perform in accordance with
its specification, for a period of five years from the date of installation.
SALUS Controls sole liability for breach of this warranty will be (at its option) to repair
or replace the defective product.
Customer Name: ......................................................................................................................................................
Customer Address: .................................................................................................................................................
............................................................................................................................................................................................
....................................................................................... Post Code: ...........................................................................
Tel No: .................................................................... Email: .......................................................................................
Engineers Company: ..........................................................................................................................................
Tel No: ...................................................................... Email: ....................................................................................
Instalation Date: ....................................................................................................................................................
Engineers Name: ...................................................................................................................................................
Engineers Signature: ...........................................................................................................................................
6. Protection Function
7. Control Patterns
5. Thermostat Functions
NSB (Night SetBack) Function
NSB Mode depends on the NSB wired connection.
0V = NSB OFF
24V= NSB ON
The NSB signal is activated every 1 second. When the signal is received the
setpoint temperature will be set at ±2°C or ±4°C.
Heating and Cooling Selection
The Heating/Cooling function is determined by the CO terminal connection.
CO 0 V= Heat mode
CO 24V= Cool mode
Cooling Blocked function
Cooling Enabled:
Set the jumper on ON . The thermostat will run in normal cooling mode.
That means that it will open/close the actuators when necessary. The LED will be
BLUE when the cooling function is running.
Cooling Disabled:
Set the jumper on OFF . The actuator will be closed and the LED will
be off.
Heat cut o at high/low temperature:
When room temperature is over 36°C or under 4°C, all heating/cooling outputs
will be turned off.
Short cycle protection:
When Cooling Mode is enabled the minimum interval between Relay ON/OFF
is 3 minutes.
Valve Protection:
Set the jumper on ON to disable the function or on OFF to enable it. Turn on the
valve for 5 minutes every week to prevent the valve any damages on the valve.
Sensor Malfunction:
If the temperature sensor or temperature sensor compensation is open the LED
will flash BLUE/RED alternatively.
If CO terminal is connected and the Heating Mode is ON, the PWM function
will be activated.
If CO terminal is disconnected and the Cooling Mode is ON the ON/OFF control
output will be activated.
HTR230 Thermostat
Vorderes Gehäuse vorsichtig abnehmen
und die Kabelverbindungen herstellen.
2. Terminalverbindung 4. Jumper
1. Montage des Thermostats 3. Schaltbrücken
Achtung: Sie können den Thermostat
direkt an das KL08 NSB Klemmleiste
(separat zu kaufen) anschließen.
Wandbefestigung
Für die Wandmontage markieren Sie
die korrekte Position an der Wand und
montieren das hintere Gehäuse an
der Wand.
Installieren Sie das Wählscheibenthermostat HTR230 etwa 1,5 m über dem Boden.
Es sollte an einem Ort montiert werden, an dem das Thermostat leicht zugänglich
und nicht direkter Sonnenbestrahlung ausgesetzt ist.
CO
N
L
ACTUATOR
30ºC
25
N
L
E.G.
HEAT
PUMP
EXTERNAL
CLOCK
230VAC
50Hz
CO
N
L
30ºC
25
Unterschiedliche Eigenschaften
des HTR230 können mit den
Jumpern an- oder ausgeschaltet
werden. Dafür befolgen Sie die
nachfolgende Tabelle.
HTR 230 Schaltbrücken
Schalter
VP Ventilschutzmerkmal
Pulsweitenmodulation
NSB-Funktion (2° oder 4°)
Heizen/Kühlen
PWM
CO
Merkmal
AN
AUS
2°C
aktivieren deaktivieren
4°C
Die Jumper von 1 bis 5 repräsentieren die Anzahl der Stellantriebe, die Sie mit dem
Thermostat verbinden können.
Nach Montage der Stellantriebe bitte den Jumper auf die korrekte Zahl schieben (die
gleiche wie die Anzahl von Stellantriebe).
Abhängig von der Anzahl der verwendeten Stellantriebe verändern Sie bitte die
Jumperposition entsprechend, um den Energieverbrauch zu kompensieren.
HTR230 Manual GE 003.indd 2 17/02/2016 11:21
2


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Salus HTR230 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Salus HTR230 in the language / languages: German as an attachment in your email.

The manual is 1,72 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Salus HTR230

Salus HTR230 User Manual - English - 2 pages

Salus HTR230 User Manual - Dutch - 2 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info