491240

Salter 1200 Manual

3
Zoom out
Zoom in
Previous page
1/19
Next page
GB
5
GB
4
USING THE SCALE
TO SWITCH TO ‘SCALE MODE’
TO MEASURE SOLIDS & LIQUIDS
a) Place the weighing platform on the
worksurface, below the display panel, with
the IR sections aligned and unobstructed.
b) If using a bowl,place it on the weighing platform.
c) The action of placing the weighing platform
on the worksurface will usually be sufficient to
switch the display to ‘scale mode’ automatically.
If not, just tap the front edge of the platform
to activate ‘scale mode’ on the display.
d) Always check that the display shows 0 before
weighing. If necessary, press the zero key to
reset the display to 0.
• To convert between grams (g) and ounces
(oz): press g-oz.
• To measure liquids: press ml-floz.
• To convert between millilitres (ml) and fluid
ounces (fl. oz): press ml-floz again.
• To switch back to solid (dry) measurement:
press g-oz.
T
O ADD ANDWEIGH
A
UTO SWITCH OFF
To weigh several different ingredients into one
bowl: press zero to reset the display between
each ingredient.
Automatic switch off occurs if the display
shows either ‘0’ or the same weight reading
for 3 minutes. (The backlight switches off after
1 minute).
When the scale switches off, the display will
automatically return to clock mode.
When display is showing time and temperature:
To change between 12 hour and 24 hour display, press g-oz briefly.
To change between °C and °F display, press ml-floz briefly.
To illuminate the display for 10 seconds, press zero briefly.
A
DDITIONAL DISPLAY FUNCTIONS IN CLOCK MODE
For correct operation a clear path is required
between the red lens on the weighing platform
and the red lens on the display panel.To help
achieve this, ensure that the IR sections on both
the display panel and weighing platform are
aligned with each other.
Note: Avoid placing large ‘overhanging’
items on the platform as this may obstruct
the IR signal. Should the IR signal become
obstructed during weighing, the display will
return to ‘clock mode’. Removing the obstruction
promptly will restore the signal.
TAP!
LOW BATTERY WARNING
Replace batteries in scale
(4 x AAA).
Always remove ‘low’
batteries promptly.
Never mix old and
new batteries or different
battery types.
Replace batteries in display
module (3 x AAA).
OVERLOAD WARNING
Total load applied exceeds
max. capacity of scale.
Remove excess load.
ADVICE & CARE
MORE ABOUT LIQUID MEASURES
The aquatronic
TM
is programmed to measure all
water based liquids. In practical terms this
covers almost every liquid used in domestic
cookery including wine, milk, cream etc.
The exception is oil, which is not water based
and would therefore not give such an accurate
measure. (The error would be approx. +10%).
CLEANING
Clean the scale with a slightly damp cloth.
DO NOT immerse the scale in water or use
chemical / abrasive cleaning agents.
All plastic parts should be cleaned immediately
after contact with fats, spices, vinegar and
strongly flavoured / coloured foods. Avoid
contact with acids such as citrus fruits.
3 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Salter 1200 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Salter 1200 in the language / languages: English, German, Dutch, Danish, French, Italian, Portuguese, Swedish, Spanish, Norwegian, Finnish as an attachment in your email.

The manual is 0,66 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info