536402

Russell Hobbs 19330-56 POWER STEAM PRO Manual

3
Zoom out
Zoom in
Previous page
1/96
Next page
3
H Don’t immerse the appliance in liquid.
7 Don’t iron clothing while it’s being worn – you’ll injure the wearer.
8 Don’t use the appliance for any purpose other than those described in these instructions.
9 Don’t scratch the soleplate – avoid buttons, zips, etc.
10 The appliance has a protective thermal fuse, which will blow if it overheats. If this happens,
the appliance will stop working, and must be returned for repair.
household use only
U BEFORE USING FOR THE FIRST TIME
•Remove any labels, stickers or packaging from the iron and soleplate.
•Don’t worry if the iron smokes a bit at first, it’ll stop as the element cures.
•Iron an old piece of cotton fabric, to clean the soleplate.
•Press the ~ and * buttons 3 or 4 times, to check them.
C AUTO SHUT-OFF
•If the iron is motionless, it will switch off after about 30 seconds with the soleplate down, or
about 8 minutes if it’s upright.
•The auto shut-off light will flash, and keep on flashing till you move the iron.
•To switch on again, lift it up, tilt it forward, then sit it upright to return to operating
temperature.
•No settings are lost during auto shut-off.
C PREPARATION
1 Check for textile care symbols (i j k l).
2 Iron fabrics needing low temperatures j first, then those that need medium temperatures
k, and finish with those needing high temperatures l.
X FILLING
3 The iron may be used with tap-water, but if you live in a hard-water area, you should use
distilled water (not chemically descaled water).
4 If you buy distilled water, check that it is marketed as suitable for irons.
5 Don’t add anything to the water – you’ll damage the iron.
6 Unplug the appliance.
7 Set the temperature control to •. Set the steam control to S.
8 Place the iron on its soleplate.
9 Open the cover.
10 Pour water from the jug into the water inlet.
11 Pour slowly, to allow the air in the reservoir to escape, and avoid an airlock.
12 Don’t fill past the max mark on the reservoir, or water will escape in use.
13 Close the cover. Wipe up any spillage.
C SWITCH ON
14 Set the temperature control to •. Set the steam control to S.
15 Sit the iron on its heel.
16 Put the plug into the power socket.
17 Turn the temperature control to bring the setting you want (see the guide below) next to the
5 mark. The thermostat light will glow.
18 When the iron reaches the set temperature, the light will go off. It will then cycle on and off
as the thermostat operates to maintain the temperature.
instructions
diagrams
1 steam control
2 temperature control
3 thermostat light
3 auto shut-off light
4 heel
5 reservoir
6 steam vents
7 soleplate
8 spray nozzle
9 cover
10 water inlet
3 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Russell Hobbs 19330-56 POWER STEAM PRO at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Russell Hobbs 19330-56 POWER STEAM PRO in the language / languages: English, German, Dutch, Danish, French, Italian, Polish, Portuguese, Swedish, Turkish, Spanish, Norwegian, Finnish as an attachment in your email.

The manual is 2,87 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info