489774

Russell Hobbs 18623-56 Allure Manual

4
Zoom out
Zoom in
Previous page
1/96
Next page
4
32 Move the handle to the right as far as it will go, to lock the filter holder in place.
C MAKING ESPRESSO
33 Put one cup under both nozzles on the filter holder, or, for two cups, put one cup under each
nozzle.
34 Wait till the thermostat light goes off.
35 Set the steam control to W.
36 You’ll hear the pump operating, and coffee will come out of the nozzles.
37 Watch the level in the cup(s).
38 Set the steam control to /.
39 This will stop the pump.
, Stop the pump just before the cups are filled to the level you want (25-30ml per shot), as the
liquid trapped in the filter will still have to come out
40 If you’re making cappuccino, go to CAPPUCCINO.
C MORE?
41 Move the filter holder handle left, till it reaches the front left corner of the appliance, then
lower the filter holder from the brewing head.
42 Empty the filter.
43 Wait till they cool, then prise the filter out of the filter holder.
44 Clean them with fresh, clean water.
45 Check the reservoir, and top up as necessary.
46 Jump to point 6.
C FINISHED?
47 Move the switch to 0.
48 Unplug the appliance.
C CAPPUCCINO
49 Cappuccino is espresso with a frothy milk top.
50 You’ll need a mug containing cold milk, and a cup to collect drips.
51 To allow room for the froth, don’t fill the mug more than two thirds full.
52 Ideally, the mug should be tall and narrow, as the milk must be deep enough to cover the end
of the frother without it hitting the bottom of the mug.
53 We’ve found that semi-skimmed milk gives better results than whole milk. You’ll need to
experiment to find which type works best for you in your area.
54 Don’t try to make too much froth at one time. Too much steam will flatten the milk, leaving
you with nothing but hot, watery milk.
C FROTHING
55 Do the frothing immediately you have made your coffee, while the appliance is still hot.
56 Swing the frother round so it’s clear of the drip tray.
57 Bring the mug containing the milk up to the frother and hold it so that the end of the frother
is just under the surface of the milk.
58 Move the frother control to S.
59 Set the steam control to Sa.
60 Steam will issue from the frother.
61 Move the jug up and down slightly, keeping the end of the frother just below the surface of
the milk.
62 Don’t lift the end of the frother out of the milk, or it’ll spatter.
63 Carry on till you have as much froth as you need.
64 Set the steam control to /.
… 4 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Russell Hobbs 18623-56 Allure at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Russell Hobbs 18623-56 Allure in the language / languages: English, German, Dutch, Danish, French, Italian, Polish, Portuguese, Swedish, Turkish, Spanish, Spanish, Norwegian as an attachment in your email.

The manual is 3,01 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info